American Standard 7440.101 Install POP-UP Drain, Remove Flange, Flange Gasket and POP-UP Knob

2 INSTALL POP-UP DRAIN

Remove CLEAR PLASTIC COVER (1).

Remove CARDBOARD SPACER (2) from under DRAIN POP-UP (3).

Tighten TAILPIECE (4) on DRAIN BODY before installing DRAIN BODY. Fig. B.

Fig. A.

1

3

2

Fig. B.

DRAIN

BODY

4

3 REMOVE FLANGE

Thread FLANGE (1) counter-clockwise and remove FLANGE (1) and FOAM GASKET (2) from drain

body. Fig. A.

Thread LOCKNUT (3) clock-wise to bottom of

drain body. Push GASKET (4) down against LOCKNUT (3). Fig. B.

Fig. A.

1

2

Fig. B.

4

3

4	INSTALL DRAIN FROM			5 TIGHTEN LOCKNUT
	BELOW FIXTURE		REAR
	From under side of SINK		OF SINK	Tighten LOCKNUT (1) firmly with Adjustable
	install DRAIN BODY (1) up	4		Wrench or Channel Locks.
	through drain outlet.
	Note: No plumber’s putty		DRAIN
	or caulk is required.		OUTLET
		3
	The CABLE ATTACHMENT
	POINT (2) must face towards
	the rear of the SINK.
	Install FOAM GASKET (3) and		1	1
	FLANGE (4) onto drain body		2
	from above SINK and tighten
	FLANGE (4) firmly.
6 FLANGE GASKET AND POP-UP KNOB			Fig. A.	Fig. B.
	Check DRAIN FLANGE in SINK to ensure that			DOWN
	WHITE FOAM GASKET (3) is fully compressed
	and not visible. Fig. A.			1
	POP-UP KNOB (1) must be fully down. Fig. B.		WHITE FOAM	DRAIN
			GASKET
			NOT VISIBLE	FLANGE
				M 9 6 5 2 2 7
			2