American Standard 7440.101 Test Installed Fitting, With Handle 1 in OFF position, turn on Water

M 9 6 5 2 2 7

10 TEST INSTALLED FITTING

With HANDLE (1) in OFF position, turn on WATER	OFF
SUPPLIES (2) and check all connections for leaks.
		ON
Remove AERATOR (3).	HOT	COLD

Operate HANDLE (1) to flush water lines thoroughly.

3

Replace AERATOR (3).			1
CHECK DRAIN CONNECTIONS
Operate POP-UP KNOB (4) and fill lavatory with water.
Check that DRAIN STOPPER (5) makes a good seal
and retains water in SINK. If DRAIN STOPPER (5)
does not seal properly, please refer to Troubleshooting		5
section in these instructions.
Release POP-UP KNOB (4) down and check all drain
connections and "P" trap for leaks. Tighten
if necessary.
			WASTE
			OUTLET
		2
		“P” TRAP	2
11 SERVICE CAUTION	Turn off hot and cold water
	supplies before beginning.

To remove or replace cartidge: Fig. A.

Turn valve to OFF position.

Remove HANDLE SCREW (2).

Pull off HANDLE (3) and CAP (4).

Unthread CARTRIDGE NUT (5) and remove.

Pull out CARTEIDGE (6).

Inspect CARTRIDGE (6) and O-RING (7) for debris and clean if necessary.

Clean MANIFOLD (1) and rinse clean.

Reinstall CARTRIDGE (6) and O-RING (7) onto MANIFLOD (1).

Reinstall CARTRIDGE NUT (5), CAP (4) and HANDLE ASSEMBLY (3).

If spout drips, operate handle several times from OFF to ON and HOT to COLD position. Do not force handles.

7 6

5 4 3

1

2

2.5mm HEX KEY

12 CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

4