Toshiba TLP451, TLP-450, TLP450U owner manual Remote control operation

Before use

(Continued)

Notes

Using batteries incorrectly can cause them to leak or burst. Strictly observe the following.

•Install the batteries with their + and – ends facing correctly.

•Do not charge, heat, disassemble, or short the batteries or throw them into a fire.

•Do not leave exhausted batteries in the remote control.

•Do not mix different types of batteries or new and old batteries.

•When you will not be using the remote control for a prolonged period, take the batteries out of the remote control.

•When the remote control stops working or only works from very close distance, replace all the batteries with new ones.

•When replacing the batteries, use a more longer life alkaline batteries.

•If a battery leaks, carefully wipe off any residue inside the battery case before loading new batteries.

Remote control operation

Point the remote control at the infrared remote sensor and press a button.

Front side Rear side

15° 15° 15° 15°

Rear side (document imaging camera model)

15° 15°

Distance : within about 5 meters from the front of the remote sensor.

Angle : within about 15° of the remote sensor in every direction.

CONTENTS 15

Notes

•The remote control may not operate when there is sunlight or other strong light such as a fluorescent lamp shining on the remote sensor.

•Operate the remote control from a position where the remote sensor is visible.

•Do not drop the remote control or otherwise jolt it.

•Keep the remote control out of locations with excessively high temperature or humidity.

•Do not get water on the remote control or place wet objects on it.

•Do not disassemble the remote control.

•Under unusual circumstances the remote control may not operate well due to the location being used or the surroundings. At such times, change the direction of the remote control to the projector and retry the operation.