Names of each part on the document camera (TDP-S81)
Preparing and using the remote control
|
| (12) |
|
| (1) |
| (11) |
|
|
| |
| (6) | (8) (9) | (10) |
|
| ||
(2) | (5) |
|
|
|
|
|
■Loading dry-cell batteries into the remote control
qRemove the battery cover.
■Operating the remote control
Point the remote control toward the projector’s infrared remote sensor, and press a button on the remote control.
• Operating the projector from the front
| (3) | (4) |
|
| (7) |
| Name | : Function |
(1) | Tray | : The document camera is mounted. |
(2) | Lock switch | : Used when the document camera is attached/detached |
|
| to/from the tray. |
(3) | Lock lever | : Locks the document camera onto the tray. |
(4) | Camera output terminal | : Used connect the supplied document camera cable to |
| (CAMERA OUT) | the COMPUTER IN (camera) terminal of the projector. |
(5) | Tip resistant bar | : Pulled out when a camera is used separated from the |
|
| projector. |
(6) | Camera arm | : Adjusts the shooting angle. p.36 |
(7) | Lock lever | : Used when the document camera is detached from the |
|
| tray. |
(8) | CAMERA button | : Toggles between the camera input and previous input. |
|
| p.36 |
(9) | CAMERA GAIN buttons | : Adjusts the camera gain. p.36 |
(10) Focusing lever | : Adjusts the focus. | |
wInsert the dry-cell batteries.
Be sure to align the plus and minus ends of the batteries properly.
Two batteries (R6, SIZE AA) are used.
eReplace the battery cover.
Approx. 15°
Approx.5m
• Operating the projector from the rear
Approx. 15°
Approx. 5m
Preparations
(11) Camera lens | : Shooting lens for the document camera. |
(12) Camera head | : Document camera. |
Dry-cell batteries
•Before using the batteries, be sure to observe the Safety Precautions described in previous pages.
•Remove batteries from remote control when not using for extended periods.
•If the remote control stops working, or if its range decreases, replace all the batteries with new ones.
The remote control
•The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting.
•Do not drop or bang.
•Do not leave in hot or humid locations.
•Do not get wet or place on top of wet objects.
•Do not take apart.
•In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation.
18 | 19 |