IMPORTANT SAFETY INSTRUCTIONS (Continued)
POWER SUPPLY CORD SELECTION
19. Replacement Parts
When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.
(Replacement of the lamp only should be made by users.)
20. Safety Check
Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.
21.Do not leave thermal- paper documents or easily deformed items on top of the unit or near the air exhaust for long periods
of time.
The heat from the unit could erase the information on the thermal paper, or cause deformation or warping.
22.Do not get your hands between the camera arm and the main unit when setting the camera arm back in its original
position. (Models equipped with document camera)
To avoid injury, be careful not to get your hands caught when setting the camera arm back in its original position.
Families with children should be particularly careful.
23. Do not carry by the camera arm.
document camera)
Do not carry the projector by the camera arm. Doing so can result in damage or injury.
24.Do not move the projector while the arm is still erect.
(Models equipped with document camera)
Always store the arm back in position when moving the projector. Otherwise injury or damage may result.
25. Do not use the product in a closed installation state.
Do not place the product in a box or in any other closed installation state. Otherwise it may overheat. This could result in a risk of fire.
If your line voltage is 220 to 240V, use one of the following types of cable. |
| Using | ||
Plug |
| Plug |
| |
configuration Plug type | Line voltage | configuration Plug type | Line voltage |
|
EURO | 220 – 240V | Australian | 200 – 240V | Before |
240V |
| |||
|
| |||
|
|
|
| |
|
| 10A |
|
|
UK | 220 – 240V | Switzerland | 200 – 240V |
|
240V |
|
| ||
|
| 6A |
|
|
Use a 5A fuse which is approved by ASTA | North American | 200 – 240V |
| |
or BSI to BSI362. |
|
| ||
Always replace the fuse cover after | 240V | |
15A | ||
changing the fuse. | ||
|
IMPORTANT PRECAUTIONS
Save Original Packing Materials
The original shipping carton and packing materials will come in handy if you ever have to ship your projector. For maximum protection, repack the set as it was originally packed at the factory.
Moisture Condensation
Never operate this unit immediately after moving it from a cold location to a warm location. When the unit is exposed to such a change in temperature, moisture may condense on the crucial internal parts. To prevent the unit from possible damage, do not use the unit for at least 2 hours when there is an extreme or sudden change in temperature.
Place and Manner of Installation
•Do not place in hot locations, such as near heating equipment. Doing so could cause malfunction, and shorten the life of the projector.
•Avoid locations with oil or cigarette smoke. Doing so will dirty the optical parts, shortening their lives, and darkening the screen.
•Do not use the product vertically in any upright position or slantwise in an angle of 20 degrees or more.
•Using this instrument near a TV or radio may cause interference to the images or audio sound. If this happens, move it away from the TV or radio.
•Moving the projector from a
•In a high altitude location where air is thin, cooling efficiency is reduced so use it with the ambient temperature being lowered.
8 | 9 |