Using the menus (Continued)
■The default setting menu
This menu shows placement status and other settings.
Default setting 1 menu
Item | Description |
|
|
No signal | Set the time to wait for the power to be turned off after the last | ||
power off | operation is made with no input signal. |
|
|
| Off (not turned off) |
| 30 min. |
|
|
| |
Auto input | Set whether the input with signals is only selected or not. |
| |
search |
| On | Off |
|
|
|
|
Beep | Beep when operation is made. | On | Off |
Power on Sets whether to turn on the power when the ON/STANDBY button is pressed (Manual), or when the power cord is plugged in (Auto).
Manual 
Auto
Lamp power Sets the lamp power. | Low | Standard |
Default setting 2 menu
Item |
|
| Description |
|
| |
Projection | Sets projection mode in accordance with Placement Style. p.22 | |||||
mode |
| (Standard) | (Rear) |
| (Ceiling) | (Rear ceiling) |
|
|
|
|
| ||
Fan mode | Sets the cooling fan speed. |
| Standard | High | ||
|
| |||||
Remote | When two or more projectors are used and controlled by the remote | |||||
control | control respectively, this menu sets the code for the projector and the | |||||
| remote control. |
|
|
|
| |
| [ | or : Enter setting mode] | [ | : Select from 1, 2, 3, 4] | ||
| [ | :Confirm] [ | :Select OK to end] |
| ||
| Press [Cancel] to return. |
|
|
| ||
Key lock Lock the control panel buttons.
[
or 
: Enter setting mode] 
[ 
: Select On/Off] 
[ 
:Confirm] 
[ 
:Select OK to end] Press [Cancel] to return.
Reset all Press 
. (The password and user logo are not reset.) Resets all adjustments and settings to their factory settings.
Detailed description [Auto input search]
[On]: Automatically searches the signals that can be projected, and switches input from the connected device that outputs the video signals each time the INPUT button is pressed. The input from the connected device that outputs no video signals is skipped.
[Off]: Displays the Input select menu.
Toggle with
buttons and press 
button. (The input without signals can be selected.)
Input select menu
Input select
Computer 1
Y/PB/PR 1
Computer 2
Y/PB/PR 2
Video
/
shows whether signal is input or not.
Yes 
No
Password | Password setting p.33 |
Detailed description [Fan mode]
Setting [Fan mode] to [High] increases the cooling fan speed. (The cooling fan noise gets louder.) Set this option to use the projector, for example, at high altitude (over 1,500 meters above sea level).
• Do not set Fan mode to [High] when using the projector at a lower altitude.
[Remote control]
Sets a remote control code from 4 types. You can set each code respectively for up to 4 projectors. The factory setting is [1].
Operations
[Power on]
Note that if [Power on] is set to [Auto], then if the power is supplied when restored after a power outage, the projector will come on.
[Lamp power]
When [Lamp power] is set to [Low], the screen becomes a little darker, but the cooling fan noise gets quieter.
To switch codes, set the same code for the projector and the remote control. A remote control code is applied after the setting is done.
•You cannot operate the remote control if the codes of the projector and the remote control do not match.
Remote control code setting for remote control
Remove the battery cover and set the same remote control code switch as the projector. p.16 p.17 (Use a screwdriver with thin tip to set.)
42 | 43 |