Toshiba TDP-T40 (XGA) owner manual Connection, Turning the power on and off, Operations

(Supplied) Power cord connector

Connection

Before connection

•Read the owner’s manual of the device you are connecting to the projector.

•Some types of computer cannot be used or connected to this projector. Check for an RGB output terminal, supported signal p.41 , etc.

•Turn off the power of both devices before connecting.

•The figure below is a sample connection. This does not mean that all of these devices can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)

		Computer
	(for control)
Audio amplifier, etc.
			Video recorder,
			DVD player, etc.
To audio input	To RS-232C terminal	p.43	To audio output	To S-Video
White (L)/Red (R)			White (L)/Red (R)	output

Turning the power on and off

■ Connecting the power cord

1 Insert the power cord connector into the AC IN socket of the projector.

2 Insert the power cord plug into a wall or other power outlet.

■Removing the lens cover

Be sure to remove the lens cover when the power is turned on. If it is left on, it could become deformed due to heat.

Audio cable	Control cable		Video cable
			(not supplied)		S-Video cable
(not supplied)					(not supplied)
			CONTROL		S-VIDEO
	MONITOR	AUDIO OUT
			R	L	VIDEO
	COMPUTER 2 IN	COMPUTER 1 IN
	( Y/PB/PR )	AUDIO IN	( Y/PB/PR )

■ Turning the power on

1 Turn on the main power switch

The ON indicator will change to orange, indicating standby mode.

TEMP

LAMPFAN

(Orange)

Operations

2 Press the ON/STANDBY button.

	Remote
Control panel	Control	Start-up screen

	RGB cable
	(not supplied)
To RGB		Audio cable
output	Audio cable	(not supplied)
		To audio
	(not supplied)
		output

To audio output

Computer Computer

	To audio		AV cable
			(not supplied)
	output
	White (L)/		To video
	Red (R)
			output
RGB cable		VCR
(supplied)
		Monitor cable Mini D-sub
To RGB
		15P-BNC
output
		(not supplied)

To Y/CB/CR output

Green (Y)/Blue (CB)/Red (CR)

Conversion adapter BNC-pin (not supplied)

DVD video recorder, etc.

The power turns on, and the following 3 green indicators light: ON, LAMP, and FAN. After a moment, the start-up screen appears.

CAUTION

•Do not look into the lens while the lamp is on. The strong light from the lamp may cause damage to your eyes or sight.

•Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.

•Do not place your hands, face, or other objects near the air exhaust. Doing so could cause burns, deform/break the object.

Notes

•COMPUTER terminals 1 and 2 function identically.

•The AUDIO IN terminal doubles for devices connected to COMPUTER terminals 1 and 2.

22 23