Print test label sample

2. PRINTER SETUP

ENGLISH VERSION

2.8 Media Sensor Calibration, Self Print Test, and Dump Mode Utilities

NOTE:

The following commands should not affect the test print issue.

D, AX, XS, Z2;1, Z2;2 (without AY)

The test print contents should be changed by the following commands and parameters:

PROGRAM VERSION: VX.XX XXXX ---	Firmware version and checksum
TONE ADJUST: +XX -------------------------	Print tone fine adjustment value
FEED ADJUST: +XX.Xmm ------------------	Print position fine adjustment value
CUT POSITION ADJUST: +XX.Xmm -----	Cut position fine adjustment value
BACKFEED ADJUST: +XX.Xmm ----------	Back feed amount fine adjustment value
PARAMETER: [PC-850][0] -----------------	Character code selection and Font “0”
	selection
[9600][8][1][NONE][0]	Baud rate, Data length, Stop bit length,
	Parity, and Transmission control of RS-
	232C
[ON][AUTO][FEED][B0]	Forward feed wait function, Control code,
	Feed key function, and Euro code
X-COORDINTE ADJUST: +XX.Xmm -----	X-coordinate fine adjustment value
SENSOR: TRANSMISSIVE [17] ------------	Sensor selection and sensitivity
MEMORY: [192KB][XXXKB]---------------	Memory capacity of the Main PC Board and
	optional memory card (0,1,2,3,4,6,8)
TTF AREA: [XXXKB][XXXKB]------------	True type font storage area, Main PC board
	and optional memory card
EXT CHAR AREA: [XXXKB][XXXKB] --	Writable character storage area, Main PC
	board and optional memory card
BASIC AREA: [XXXKB][XXXKB] --------	BASIC file storage area, Main PC board and
	optional memory card
PC SAVE AREA: [XXXKB][XXXKB] -----	PC save storage area, Main PC board and
	optional memory card
INFORMATION: -------------------------------	Printed only when some information is
	stored in the flash ROM
TOTAL FEED-----------------------------------	Total feed distance

E2-11