APPENDIX 1 SPECIFICATIONS | ENGLISH VERSION |
| A1.3 Media |
|
|
A1.3.1 Media Type (Cont.)
|
|
|
| Unit: mm (inch) | |
|
|
|
|
| |
Issue mode | Batch mode |
| Strip mode | Cut mode | |
Item |
| ||||
|
|
|
| ||
Width including backing paper | 25.4 to 112 (1.0 to 4.4) |
| |||
Media width |
|
| Min. 17 (0.7) |
| |
Media pitch | 10 to 1000(0.39 to 39.3) |
| 25.4 to 1000 (1.0 to 39.3) | ||
Media length | Min. 10 (0.39) |
| Min. 25.4 (1.0) | ||
Gap length (or black mark length) | Min. 2 |
| Min. 6 | ||
Black mark width |
|
| Min. 8 |
| |
Thickness |
|
| 0.06 to 0.19 |
| |
Max. outer roll diameter |
|
| Ø127 (5) |
| |
Ø214 (8.4): When the optional External Media Roll Hanger is used. | |||||
| |||||
Roll direction |
| Either is acceptable. |
| ||
Outside roll media; Linerless paper (option) | |||||
| |||||
Inner core diameter | 25.4, 38.1, or 76.2 (1, 1.5, or 3) (See NOTE 2.) | ||||
NOTES:
1.To ensure print quality and print head life use only TOSHIBA TEC approved media.
2.When using a media roll of
A1.3.2 Detection Area of the Transmissive Sensor
The Transmissive Sensor is positioned 6 mm from the centre.
The Transmissive Sensor detects a gap between labels, as illustrated below.
Centre of media
|
|
|
|
|
| Area to be detected. | ||||
Sensor position | ||||||||||
|
|
|
|
|
|
|
|
| Label | |
|
|
|
|
|
|
|
|
| ||
Min. 2 mm |
|
|
|
|
|
|
|
|
| Gap |
|
|
|
|
|
|
|
|
| ||
(Min. 6 mm: |
|
|
|
|
|
|
|
| Label | |
cut mode) |
|
|
|
|
|
|
| |||
|
|
|
|
| Min. 8 mm | |||||
Sensor position
Print side
Media feed direction
6 mm
A1.3.3 Detection Area of the Reflective Sensor
The Reflective Sensor is movable within the full range of the media width.
The reflection factor of the Black Mark must be 10% or lower with a waveform length of 950 nm. The Reflective Sensor should be aligned with the centre of the Black Mark.
Sensor should be positioned at the centre of the black mark.
Min. 2 mm 
(Min. 6 mm:
Cut mode)
Min. 8 mm
Detecting the black marks on the back.
Media feed direction
Sensor is movable within the full range.
EA1- 3