Kustom WAV 212 owner manual Rear Panel, AC Fuse

	30			Rear Panel					34
ON		MODEL wAv 212
		CAUTION
		RISK OF ELECTRIC SHOCK
		DO NOT OPEN
		ATTENTION
		RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
OFF					FOOTSWITCH	LEFT	RIGHT	LEFT		RIGHT
						Line Out	Line Out	PREAMP	POWER	PREAMP	POWER
POWER
								Out	AMP IN	Out	AMP IN
		SERIAL NUMBER
AC FUSE
FUSE: T2A / 250V				CAUTION	ATTENTION
120V	60Hz 160W	DESIGNED IN USA	MADE IN CHINA
				CHASSIS SURFACE HOT	SUPERFICE DE CHASSIS CHAUDE
29	31	TAB			32	33				35

Power ON/OFF Switch:

Turns AC power on and off.

AC Power Cord Receptacle:

Insert the AC cord (provided) firmly into the AC connector. NOTE: Replace the AC power cord if protective jacket is damaged or ground pin is damaged or removed.

FUSE:

The fuse is located in a housing just below the receptacle. Replace only with same type and size. To remove the fuse, remove AC power cord and pull out on the tab above the fuse symbol located on the fuse carriage. Place the new fuse in the carriage clip and re-insert. NOTE: To prevent an electrical hazard, DO NOT replace fuse without using the fuse carriage. Replace the fuse carriage if lost or damaged before re-inserting the AC power cord.

Footswitch Jack:

Plug Footswitch into this connector using the supplied cable. If the cable is lost or damaged, a standard CAT 5 cable can be used. CAT 5 cables can be purchased at your local retail electronic and computer stores.

Left and Right Line Out:

These ¼” mono jacks deliver the signal going to the speakers at an unbalanced line level. The main purpose of these jacks is to deliver line level outputs to external sound reinforcement devices such as powered monitors or speakers. They will not drive external non-powered speakers. To prevent an undesirable feedback oscillation, do not use these jacks on signal processors or effects that will be using the power amp input jacks.

Left and Right Preamp out:

These ¼” mono jacks deliver an unbalanced line level output from the preamp and digital effects. The main purpose of these jacks is to send a signal to the input of third party signal processors or effects that will be using the power amp input jacks. These jacks do not interrupt signal flow from the preamp to the power amp.

Left and Right Power Amp In:

These ¼” mono jacks allow the left and right power amplifiers to be used with an external line level input. The main purpose of these jacks is to receive the return signal from a third party signal processor or effect. NOTE: When used, these jack will interrupt the signal flow from the preamp to the power amp.

8