MartinLogan E2 manual Transition/Electrostatic Tower Assembly

Page 10

Transition/Electrostatic Tower Assembly

Note: The following instructions describe the assembly of the right channel high-and mid-frequency tower. Duplicate all assembly instructions for the left tower assembly.

1 Attach the outside (semi-circle shaped) trim rail to the transition tower by aligning the five pins on the trim rail with the 5 cam holes in the tower.

Figure 15

2 Use a phillips head screwdriver to rotate the cams a little over 180° counter clockwise once the pin is properly aligned in the cam. The arrow on the cam must be in the position shown to accept the pin.

Figure 16

3 Make sure the trim rail is flush with the tower edge.

Figure 17

10 Assembly

Image 10

Contents A T E M E N T TM E Contents Required Tools Before YOU BeginMaster Packing List Unpacking the Statement E2Wall Behind the Listener Speaker PlacementInitial Speaker Placement Wall Behind the SpeakersAssembly Subwoofer Tower AssemblyAssembly Assembly Assembly Assembly Transition/Electrostatic Tower Assembly Finished transition tower assembly Assembly Assembly Assembly Assembly Tighten frame bolts as shown Assembly Assembly Assembly Assembly Exos signal inputs. Balanced connection shown CONNECTIONS-EXOS Crossover InputsSubwoofer Outputs CONNECTIONS-EXOS Crossover OutputsFull Range Outputs CONNECTIONS-ESL/TRANSITION Towers Bi-Wire ConnectionHorizontal Passive Bi-Amplification Vertical Passive Bi-Amplification Vertical passive bi-amplification. One Channel shownOhm Connection CONNECTIONS-SUBWOOFER TowersOhm/Bi-Amp Connection Passive HIGH-PASS Settings High-Pass SettingsOpen not connected jumpers AC Power Connections Exos E2.5 IEC power cord AC receptacleMaking It Work Together Part Setting the Dip SwitchesMaking IT Work Together Subwoofer Level KnobFive setting options for the 25Hz and 50Hz dip switches Making It All Work Together PartHard Sound Speaker Placement Fine TuningESL Tower Spike Installation Tweaking the RoomMartinLogan, All rights reserved Rev. #100203