MartinLogan E2 manual Open not connected jumpers

Page 27

Figure 56. Open (not connected) jumpers.

Figure 58. Jumper settings for 10-foot mode.

Figure 60. Jumper settings for all-open mode.

Figure 57. Closed (connected) jumpers.

Figure 59. Jumper settings for all-closed mode.

Figure 61. Jumper settings for 15-foot mode.

Passive High-Pass Settings 27

Image 27

Contents A T E M E N T TM E Contents Unpacking the Statement E2 Before YOU BeginMaster Packing List Required ToolsWall Behind the Speakers Speaker PlacementInitial Speaker Placement Wall Behind the ListenerSubwoofer Tower Assembly AssemblyAssembly Assembly Assembly Assembly Transition/Electrostatic Tower Assembly Finished transition tower assembly Assembly Assembly Assembly Assembly Tighten frame bolts as shown Assembly Assembly Assembly Assembly CONNECTIONS-EXOS Crossover Inputs Exos signal inputs. Balanced connection shownCONNECTIONS-EXOS Crossover Outputs Subwoofer OutputsFull Range Outputs Bi-Wire Connection CONNECTIONS-ESL/TRANSITION TowersHorizontal Passive Bi-Amplification Vertical passive bi-amplification. One Channel shown Vertical Passive Bi-AmplificationCONNECTIONS-SUBWOOFER Towers Ohm ConnectionOhm/Bi-Amp Connection High-Pass Settings Passive HIGH-PASS SettingsOpen not connected jumpers Exos E2.5 IEC power cord AC receptacle AC Power ConnectionsSubwoofer Level Knob Setting the Dip SwitchesMaking IT Work Together Making It Work Together PartMaking It All Work Together Part Five setting options for the 25Hz and 50Hz dip switchesTweaking the Room Speaker Placement Fine TuningESL Tower Spike Installation Hard SoundMartinLogan, All rights reserved Rev. #100203