Siemens 175V manual Important notes, Safety

Page 10

Color monitor 175V

Important notes

!

In this chapter you will find information regarding safety which is essential to take note of

with your monitor.

 

Safety

This device complies with the relevant safety regulations for data processing equipment, including electronic office machines for use in an office environment. If you have any questions, contact your sales outlet or our Help Desk.

If the device is brought into the installation site from a cold environment, condensation can form. Before operating the device, wait until it is absolutely dry and has reached approximately the same temperature as the installation site.

During installation and before operating the device, please observe the instructions on environmental conditions in the chapter entitled "Technical data" as well as the instructions in the chapter "Installing an ergonomic video workstation".

To ensure adequate ventilation the monitor may only be operated with the monitor foot installed.

The color monitor must not be exposed to strong magnetic fields (e. g. caused by magnetic paper clip holders or loudspeakers). Strong magnetic fields could result in a permanent blotchy image.

The monitor is automatically degaussed when switched on. This results in a magnetic field around the metal edge of the picture tube, which may damage the data on data carriers nearby. Therefore, never keep magnetic data carriers near the monitor.

The device automatically sets itself to the correct voltage within the range from 100 V to 120 V and 200 V to 240 V. Ensure that the local mains voltage lies within these limits.

The device must be installed in such a way that the user has good access to the appliance socket.

The ON/OFF switch does not disconnect the device from the line voltage. To disconnect the line voltage completely, remove the power plug from the socket.

Lay all cables so that nobody can stand on them or trip over them. When attaching the device, observe the relevant notes in the chapter "Connecting the monitor".

No data transmission cable should be connected or disconnected during a thunderstorm.

Please ensure that no objects (e. g. necklaces, paperclips etc.) or liquids can get into the interior of the device (this may cause an electrical shock or short circuit).

In emergencies (e. g. damaged casing, elements or cables, penetration of liquids or foreign matter), switch off the unit, disconnect the power plug and contact your sales outlet or our Help Desk.

Only qualified technicians should repair the device. Unauthorized opening and incorrect repair may greatly endanger the user (electric shock, fire risk).

Tampering with the device, in particular adjusting the high voltage or installing a different type of CRT tube, may result in a large amount of X-ray radiation being emitted. Devices modified in this way no longer comply with their license and may not be used.

You may set only those resolutions and refresh rates specified in the "Technical data" chapter. Otherwise you may damage your monitor. If you are in any doubt, contact your sales outlet or Help Desk.

2 - English

A26361-K609-Z100-2-5E19

Image 10
Contents 175V Sie haben Page A26361-K609-Z100-1-5E19 Betriebsanleitung Operating Manual Ausgabe Mai 2000 May 2000 editionPage Contents Page Target group IntroductionNotational conventions Further informationSafety Important notesTransport notes Cleaning note175VManufacturers notes Energy StarImportant note on power cable FCC Class B Compliance StatementDisposal and recycling Power cable for devices distributed in the US and CanadaFor the United Kingdom Checking the contents of the consignment Installing an ergonomic video workstationAttaching the monitor base Connecting the monitor Operation of the monitor Switching the monitor on Switching the monitor offChanging the monitor settings Settings with the OSD menuAdjusting size and position Adjusting the brightness and contrastSetting the picture geometry 500K Setting color temperature and colorsSetting moiré reduction 300KActivating the factory settings Masking out the OSD menuAccessories Storable display modes Electrical data Technical dataDimensions and weight Environmental conditionsPreset operating modes VESA-DDC-compatible VGA interfaceError handling Pin assignment D-SUB 15-pinScreen is blank power indicator lights Screen is blank power indicator does not lightHumming noise is heard after switch-on