SETUP – MK1031GAS (HDD2A02)
Caution: Your Hard Disk Drive is a precision device and even a small drop onto any surface can cause damage. Electronstatic discharge can also damage the drive. You should ground yourself prior to handling the drive.
Master/Slave Settings
Your Toshiba Hard Disk Drive can be configured as either a "Master" or "Slave" unit. Master configuration is used for all single drive applications, and master or slave configuration (only one of each per port) is used for two drive applications. Use the information in the following table before setting drive as Master or Slave.
Master configuration is obtained by setting jumpers A, B, C & D open (no jumper present). Slave configuration is obtained by setting jumpers
Figure 1.HDD Jumper Locations
JUMPER | P28 | DRIVE |
No Jumper | - | Master Drive |
|
|
|
- | Slave Drive | |
|
|
|
LOW | Master Drive | |
|
|
|
HIGH | Slave Drive | |
|
|
|
- | Slave Drive | |
|
|
|
- | Prohibit | |
|
|
|
Installation Notes
The drive should be mounted carefully on the surface of 0.1mm or less flatness to avoid excessive distortion.
In order to prevent
Space should be kept around the drive to avoid any contact with other parts, which may occur due to shock or vibration.
The temperature of the top cover and the base must always be kept under 60C to maintain the required reliability.
Be sure not to cover the breathing hole to keep the pressure inside the drive at a certain level
Do not apply any force to the top cover, except the screw areas on top cover. Maximum force to the specified area is 2N.
The drive contains several parts which may be easily damaged by ESD (Electric Static Discharge). Avoid touching the interface connector pins and the surface of PCB. Be sure to use ESD proof wrist strap when handling drive.
The four mounting screws should be tightened equally with
2