Whirlpool ET20GM Install properly, Level refrigerator-freezer, Remove sales labels, Clean it

Install properly... .

1.Allow Y2inch (1.25 cm] space on each side and

at the top of the refrigerator for ease of installation.

2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wider.

3.The refrigerator back can be flush against the wall.

s?sF‘-’:.!i“--; Y’ --iii da?.’

Level refrigerator-freezer...

SCREWDRIVER

TO ADJUST

ELLING SCREW

LEFTTO LOWER

1.Remove base grille (see page 7).

2.To raise front, turn the screw in the direction shown.

3.To lower front, turn the screw in the direction shown.

4.Check with level.

5.Replace base grille (see page 7).

Remove sales labels.. .

Remove the Consumer Buy Guide label, tape and any inside labels before using the re- frigerator. To remove any remaining glue:

1.Rub briskly with thumb to make a ball then remove.

OR

2.Soak area with liquid hand dishwashing detergent before removing glue as described in step 1.

DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car-

bon tetrachloride, etc. These can damage the material.

NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTIONS LABELS INSIDE YOUR REFRIGER- ATOR.

Do not remove the Tech sheet fastened under

the refrigerator at the front.

SC>-4bx5;s:a‘b~d‘eiill*.* S>“Yis.1u-I..II~WCrbDLhl~L. B*--I(y:*EIptEI?41

Clean it...

Clean your refriger- ator before using it.

See cleaning instruc

Plug it in...

3-PRONG GROUNDING TYPE WALL RECEPTACLE

REFRlGERAibR			I-PRONG			-
			GROUNDING			PLUG
POWER CORD
RECOMMENDED			GROUNDING		METHOD
A 115 Volt, 60 Hz., AC only				15 or 20		ampere fused
and	properly		grounded	electrical		supply	is
required.		It is recommended			that a separate		cir-
cuit	serving	only	this appliance		be	provided.

Do not use an extension cord. Use a recepta- cle which cannot be turned off with a switch or pull chain. See individual electrical requirements and grounding instruction sheet in your literature package.

4