Changing the light bulbs...
2. Remove bulb.
3. Replace with a 40.watt appliance bulb.
r.. | ./ | _I z | .3lkkw | ~~~~.‘ii~. | Al | i. | ^. |
Removing the base grille...
r METAL CLIPS
To remove the grille:
7 SUPPORT TABS
1. Open the door. |
|
|
|
|
|
|
|
| |||
2. | Pull | grille | outwards | as | shown. |
| 1. | Line | up grille | support tabs with metal clips. | |
3. | Do | not | remove | Tech | sheet fastened | behind | 2. | Push | firmly | to | snap into place. |
| grille. |
|
|
|
| 3. | Close | the | door. | ||
|
|
|
|
|
|
| |||||
Ice cube trays...
(Model ETPOGK)
If cubes are not used, they may shrink. The mov- ing cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.
To remove ice:
1.Hold tray at both ends.
2.Slightly twist.
Automatic ice maker...
If you have Model ET20GM and have the auto- matic ice maker accessory, or if you have Model ET20GK and plan to add one later (Part No.
l The ON/OFF lever is a wire signal arm. Downfor making ice automatically. Up...to shut off the ice maker.
DO NOT TURN ICE MAKER ON UNTIL IT IS CON- NECTED TO THE WATER SUPPLY.
l The dial or lever on the side of the ice maker changes the size of the cubes.
l Shake the bin occasionally to keep cubes sepa- rated, and to obtain increased storage capacity.
l It is normal for ice crescents to be attached by a corner. Thev will break abart easilv.
l You will hear water running when ice maker is working. You’ll hear ice fall into the bin. Don’t let these sounds bother you.
l
l
l
RAISE
SIGNAL
ARM TO
STOP ICE
The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight.
Because of new plumbing connections, the first ice may be discolored or
It ice is not being made fast enough and more ice is needed, turn the Refrigerator Control to- ward a higher number. Wait a day and, if neces- sary, turn the Freezer Control toward A.
