Remote control operation is not possible.
The rear panel control input jack on the player is being used.
\Point the remote control at the component that the player is connected to (page 19).
The remote control is too far from the player, or the angle with the remote sensor is too wide.
\Be sure to operate the remote from a location within its operating range (page 8).
The batteries are exhausted.
\Replace the exhausted batteries with all new batteries (page 8).
Audio is not output or is distorted.
The Setup screen Audio 1 menu [96 kHz PCM Out] setting is set to “96 kHz”.
\On DVDs that contain copy protection, it may not be possible to play back the audio at 96 kHz. When this type of disc is encountered, even if “96 kHz” is selected, the player automatically outputs the digital audio output at a compressed rate of 48 kHz. This is not a malfunction.
\The “4:3 (Letter Box)” screen setting is selected. Even if “96 kHz” is selected, the player automatically downsamples the audio to a compressed rate of 48 kHz. This is not a malfunction.
\Be sure to make analog audio connections as well as digital connections (page 17).
The disc is dirty.
\Refer to “Disc Care” (page 71).
The connection plugs are not inserted fully into the terminals or are not connected.
\Check that all connection plugs are firmly inserted.
The connection plug or terminal is dirty.
\Check that the plugs and terminals are wiped clean of dirt, etc.
Audio cable connection is wrong.
\Check to make sure that the audio cables are connected correctly (page 17).
Connection is made to the stereo amplifier‘s PHONO input terminal.
\Change connection to any input terminal except
PHONO.
The pause mode is engaged.
\Press PLAY 3 or PAUSE 8 to exit the pause mode.
Stereo amplifier operation is incorrect.
\Check input (CD, AUX, etc.) selector to determine if it is selected for DVD playback.
External input settings are incorrect.
\Check that the power of the component to be used for external audio input has been turned on.
\Check that the Setup screen General menu “External Input” setting is correct (page 68).
The DTS audio soundtrack on a DVD has been selected.
\There is no audio output from the analog jacks during DTS audio playback. Select another soundtrack.
Noticeable difference in DVD and CD volume.
DVDs and CDs use different recording methods.
\This is not a malfunction.
There is no video and/or audio output from a SLAVE
Connections are incorrect.
\Check that connections are made firmly from the output jacks on the other component to the IN jacks on this unit (pages 66 and 67).
Menu settings are incorrect
\Check that the Setup screen Other menu [External Input] setting is set appropriately (page 68).
The SLAVE DV-F727 does not operate when connected
Connections are incorrect.
\Check that the control cable is connected to the MASTER jack on this unit and the SLAVE jack on the connected
\When connections are not made correctly or transmission cannot be performed between the Master and Slave player, “CONNECT ERR” is displayed in the display window. If this message is displayed, connect the cord correctly (page 66).
Caution
Static electricity or other external influence may cause malfunctioning of this unit. In this case, unplugging the power cord and then
Resetting the Player to System Settings
To reset the player, press and hold 7 (stop) on the front panel when pressing 
STANDBY/ON on the front panel to turn the unit from standby to on.
All input text data, program memory, saved settings ADDITIONAL from functions such as Function Memory and
Condition Memory are cleared, and all Setup screen menus are returned to factory settings.
INFORMATION
75
