Pioneer DV-F727 Before Using, Checking Accessories, Preparing the Remote Control

Before Using

Checking Accessories

Please confirm that the following were received with the player.

Audio cord

Preparing the Remote Control

Inserting batteries into the remote control

1 Push down on the tab on the battery compartment cover, and pull out in the direction indicated by the arrow.

Video cord

Master-Slave control cord

Remote control unit

AA/R6P batteries

Operating instructions (this manual) Warranty card (U.S. and Canadian models only)

Remote control operation

ë￿

30°
7 m	30°	4	1	¢￿
				Á￿
(23 ft.)		7		8
		3

8

2 Insert batteries.

Make sure to match the plus (+) and minus

(–)polarity guides on the batteries with the marks inside the battery compartment.

3 Close the cover.

Notes

•Do not mix old and new batteries.

•When replacing batteries, use all new batteries.

•When not using the remote control for a long period of time (over 1 month), remove the batteries to avoid possible damage from battery corrosion. If battery leakage occurs, wipe the battery liquid from the battery component, then insert new batteries.

When operating the remote control, point it at the remote sensor (ë) located on the player’s front panel. The remote control can be used up to 7 m (23 feet) from the player and within a 30° angle on each side of the sensor.

Notes

•Exposing the remote sensor to direct sunlight or strong light may cause faulty operation.

•When Master-Slave connections are made to another DV-F727 to create a 601-disc changer, only the remote sensor on the first DV-F727 will accept signals from the remote control (page 66).

•If the CONTROL IN jack on the player’s rear panel is connected to the CONTROL OUT jack of another component, point the remote control at the other component to operate the player. Operation will not be possible when pointed at this player (page 19).