WHP150 MANUAL(1J1500 ) 6/10/99 11:28 AM Page 4
INSTALLATION OF TRANSMITTER
1)Connect the supplied AC power adapter to an electrical wall outlet.
2)Plug the AC power Adapter into the DC jack located on the rear of the transmitter.
Charge | AC/DC | Green |
Adapter | ||
Output |
| LED |
Jack | Audio |
|
|
| |
| Cord |
|
3)Locate the audio cord connected at the back of the transmit- ter. The 3.5 mm plug provided can be used to connect the transmitter to the headphone jack of any audio source.
If your equipment has a 1/4” size jack, use the adapter plug included with the headphone.
For connection to RCA type phono jacks located on the back of a TV, VCR or A/V receiver, use the “Y” adapter that is included. Just insert the mini plug on the audio cord into the jack on the adapter to convert the connector for this applica- tion. Then insert the red and white RCA plug ends into the equipment jacks marked “Audio Out” to make the audio source connection (see diagram).
4
AUDIO
INPUT
Audio |
| LEFT |
| RIGHT | |
Cord | 1/4" adapter | “Y” adapter |
|
INSTALLATION OF BATTERIES
1)Open the battery compartment cover on the right side of the headphone.
2)Insert two AA size
3)Replace the cover and you are ready to charge the batteries.
Battery
Door
5
