Computer Problems
The computer fails the POST
The computer POST (Power On Self Test) ensures that all hardware is working properly before starting the remainder of the boot process. If the computer passes the POST, the computer continues to start normally. However, if the computer fails the POST, the computer emits a series of beeps during start‑up. The following repetitive beep codes help you troubleshoot problems with your computer.
For assistance, contact Alienware (see “CONTACTING ALIENWARE“ on page 66).
NOTE: To replace parts, see the Service Manual at support.dell.com/manuals.
Beep Code | Possible Problem |
One | Possible motherboard failure — BIOS ROM checksum failure |
Two | No RAM detected |
| NOTE: If you installed or replaced the memory module, ensure |
| that the memory module is seated properly. |
Three | Possible motherboard failure — Chipset error |
Four | RAM read/write failure |
Five | Real Time Clock failure |
Six | Video card or chip failure |
Seven | Processor failure |
CHAPTER 6: TROUBLESHOOTING
51