Metra Electronics 99-7308 installation instructions Shaft Head Units Slide the aftermarket

ALL VEHICLES
3		4
Fig. A		A
		B
		C
		D
	Fig. B	A) Strip wire ends back ½"
		B) Twist ends together
		C) Solder
		D) Tape
2-SHAFT HEAD UNITS: Slide the aftermarket		Locate the factory wiring harness in the
head unit into the Radio Housing	and secure	dash. Metra recommends using the
with shaft nuts. (see Fig. A).		proper mating adaptor and making
DIN HEAD UNITS: Cut and remove the shaft		connections as shown. (Isolate and
supports from the Radio Housing.	Slide the DIN	individually tape off the ends of any
cage into the kit and secure by bending the metal		unused wires to prevent electrical short
locking tabs down. Slide the aftermarket head		circuit).
unit into the cage until secure. (see Fig. B)

5

Fig. A

ACCENT: Re-connect the battery terminal and test the unit for proper operation. Mount the head unit/kit assembly to the sub-dash with (4) Phillips screws previously removed in step #1. ELANTRA, TIBURON: Re-connect the battery terminal and test the unit for proper operation. Mount the head unit/kit assembly to the sub-dash with (4) #10 x ¾" Phillips Truss-head Screws supplied.

	SONATA: Re-connect the battery terminal and test the unit for proper operation. Mount the
	factory pocket to the sub-dash with (4) Phillips screws previously removed in step #1. Mount
	the head unit/kit assembly to the sub-dash with (4) Phillips screws previously removed in step
3	#1. (see Fig. A).
	rev. 06-14-07

KIT FEATURES

Shaft and DIN head unit provisions

KIT COMPONENTS

Radio Housing

Spacer 1L

Spacer 1R

(4)#10 x ¾" Phillips Truss-head Screws

TOOLS REQUIRED

Phillips screwdriver

Cutting tool

Adjustable wrench

99-7308

INSTALLATION

INSTRUCTIONS

APPLICATIONS
CAR		PAGE
HYUNDAI
Accent 1995-99		1
Accent 2002-05		1
Elantra (single DIN)	1996-00	1
Sonata (Single DIN) 1995-98		2
Tiburon (single DIN)	1997-02	2

1-800-221-0932 www.metraonline.com

© COPYRIGHT 2001-07 METRA ELECTRONICS CORPORATION