HYUNDAI Accent 1995-99 / 2002-2005
12
HYUNDAI Sonata (single DIN) 1995-98
12
"A"
Fig. A
Disconnect the negative battery terminal to prevent
an accidental short circuit. For
Disconnect (2) vent cables from the vent levers located behind the driver's side dash. Unclip the dash trim bezel and disconnect the wiring. Remove
(4)Phillips screws securing the factory head unit and disconnect the wiring.
Locate the Radio Housing. Skip to the
Installation Instructions for ALL VEHICLES on Page #3.
Disconnect the negative battery terminal to prevent an accidental short circuit. Unclip the gear shifter trim panel and remove (1) screw exposed. Unclip the dash trim bezel and remove. Remove (4) Phillips screws securing the factory head unit and disconnect the wiring. Cut and remove tabs "A" located in the top corners of the dash cavity.
Locate the Radio Housing. Skip to the
Installation Instructions for ALL VEHICLES on Page #3.
HYUNDAI Elantra (single DIN) 1996-00
12
"1L"
"1R" 
HYUNDAI Tiburon (single DIN) 1997-02
12
"1L"
"1R"
Disconnect the negative battery terminal to prevent an accidental short circuit. Pop out the dimmer switch panel and remove (1) Phillips screw exposed. Unsnap the gear shifter trim plate and remove (1) Phillips screw exposed at the base of the dash trim bezel. Reach under the driver's side dash, locate the teperature control cable and remove the cable from the white plastic bracket. Position the gear shifter in low, pull the dash panel away and disconnect all wiring harnesses. Remove the trim bezel (the temperature control cable will be attached). Remove (4) Phillips screws securing the factory head unit and disconnect the wiring.
Attach Spacer 1L to the left mounting tab of the Radio Housing and Spacer 1R to the right mounting tab of the Radio Housing as shown. Skip to the Installation Instructions
for ALL VEHICLES on Page #3.
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove
(4)Phillips screws securing the center console. Pry out on the front edge of the console and unclip the radio trim bezel. Remove (2) Phillips screws securing the factory pocket and remove. Remove (4) Phillips screws securing the factory head unit and disconnect the wiring.
Attach Spacer 1L to the left mounting tab of the Radio Housing and Spacer 1R to the right mounting tab of the Radio Housing as shown. Skip to the Installation Instructions
for ALL VEHICLES on Page #3.
1 | 2 |