Unpacking and installing the Dell | 1 |
Perform the following steps to remove the switch module from its shipping package.
1.Open the shipping box and inspect the contents, making sure that nothing is missing or damaged.
Do not insert a damaged converged network switch into the Blade Blade Server Enclosure. If the converged network switch appears to be damaged, contact your sales representative before proceeding.
2.Remove the cardboard accessory tray from on top of the converged network switch.
This tray contains the documentation, regulatory statements, product information guide, and Documentation CD.
3.Remove the switch module from the box.
The protective foam ends will slide out with the switch module.
4.Remove the foam ends from the switch module.
5.Be sure that you have taken the necessary precautions for electrostatic sensitivity; then break the seal warning.
6.Slide the switch module out of the antistatic sleeve and inspect it carefully for any obvious defects or shipping damage.
7.For complete instructions to install the converged network switch into the Blade Server Enclosure, refer to the section on installing answitch module in the Blade Server Enclosure Hardware Owner’s Manual.
NOTE
Be sure to remove the protective covers from the midplane connectors before installing the module into the enclosure.
Dell | 7 |
|