Dell 435MT manual Replacing the Battery

Page 8

Back to Contents Page

Replacing the Battery

Dell Studio XPS™ 435MT Service Manual

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

WARNING: A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions.

1.Record all the screens in system setup (see System Setup) so that you can restore the correct settings in step 10.

2.Follow the procedures in Before You Begin.

3.Remove the computer cover (see Replacing the Computer Cover).

4.Locate the battery socket (see System Board Components).

CAUTION: If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with the object. Ensure that the object is inserted between the battery and the socket before you attempt to pry out the battery. Otherwise, you may damage the system board by prying off the socket or by breaking circuit traces on the system board.

1 battery (positive side) 2 battery release lever

5.Carefully press the battery release lever away from the battery and the battery will pop out.

6.Remove the battery from the system and properly dispose of the battery.

7.Insert the new battery into the socket with the side labeled "+" facing up, then snap the battery into place.

1 battery (positive side) 2 battery release lever

8.Replace the computer cover (see Replacing the Computer Cover).

9.Connect your computer and devices to electrical outlets, and then turn them on.

10.Enter system setup (see System Setup) and restore the settings you recorded in step 1.

Back to Contents Page

Image 8
Contents Page Replacing the Badge Back Light Technical Specifications Safety InstructionsBefore You Begin Recommended ToolsBack to Contents Replacing a PCI Express Card Removing a PCI Express CardInstalling a PCI Express Card Disabled Enabled Replacing the Card Retention BracketReplacing the Battery Replacing the Computer Cover Replacing the Processor Page Back to Contents Replacing Drives Replacing a Hard DriveReplacing an Optical Drive Replacing the FlexDock Replacing the Drive Panel Insert Removing the FlexDock Break-Away Metal PlateReplacing the FlexDock Drive Inserts Back of the computer Drive panel insert optional Replacing the Chassis Fan Replacing the Processor Fan and Heat Sink AssemblyReplacing Fans Back to Contents Replacing the Front Panel Replacing the Front I/O Panel Page Replacing Memory Modules Back to Contents Replacing the Power Supply Back to Contents Replacing the Rubber Foot Replacing the System Board Back to Contents System Setup OverviewStandard Cmos Features Boot Sequence Clearing Forgotten Passwords Clearing Cmos SettingsFlashing the Bios Click Save this program to disk, and then click OKSystem Board Components Technical OverviewInside View of Your Computer SATA3 Back to Contents Replacing the Top Cover Back to Contents Replacing the I/O Panel
Related manuals
Manual 60 pages 17.41 Kb