13.Replace the computer cover (see Replacing the Computer Cover).
14.Connect your computer and devices to their electrical outlets, and turn them on.
NOTE: If you installed a new drive, see the documentation that came with the drive for instructions on installing any software required for drive operation.
Replacing the FlexDock
1.Follow the procedures in Before You Begin.
2.Remove the computer cover (see Replacing the Computer Cover).
3.Remove the front panel (see Replacing the Front Panel).
1 | custom screws (2) | 2 | FlexDock USB connector (F_USB4) |
|
|
|
|
3 | FlexDock USB cable | 4 | FlexDock |
|
|
|
|
4.Disconnect the FlexDock USB cable from the back of the FlexDock and from the FlexDock USB connector (F_USB4) on the system board (see System Board Components).
5.Remove the two screws securing the FlexDock.
6.Slide the FlexDock out through the front of the computer.
7.If you are not replacing the FlexDock, replace the drive panel insert (see Replacing the Drive Panel Insert) and proceed with step step 13.
8.If you are installing a new FlexDock:
a.Remove the drive panel insert, if applicable (see Replacing the Drive Panel Insert).
b.Remove the FlexDock
c.Remove the FlexDock from its packaging.
9.Gently slide the FlexDock into place in the FlexDock slot.
10.Align the screw holes on the FlexDock with the screw holes on the FlexDock slot.
11.Replace the two screws that secure the FlexDock.
NOTE: Ensure that the FlexDock is installed before the FlexDock cable is connected.
12.Connect the FlexDock USB cable to the back of the FlexDock and to the FlexDock USB connector (F_USB4) on the system board (see System Board Components).
13.Replace the front panel (see Replacing the Front Panel).