Dell E6440 owner manual Removing the Network Connector, Installing the Network Connector

3.Install:

a.base cover

b.battery

4.Follow the procedures in After Working Inside Your Computer.

Removing the Network Connector

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove:

a.battery

b.base cover

c.base corner cap (left)

3.Perform the following steps as shown in the illustration:

a.Disconnect the cable from the system board [1].

b.Release cable from the routing channel [2].

c.Remove the screw that secures the network-connector bracket to the computer.

4.Remove the network-connector bracket from the computer. Lift the network connector from the computer.

Installing the Network Connector

1.Align the network connector to its position on the computer.

2.Place the network-connector bracket on the network connector.

3.Tighten the screw to secure the network-connector bracket to the computer.

4.Route the cable through the routing channel.

5.Connect the cable to the system board.

23