Dell E6440 owner manual Removing the Camera, Installing the Camera

Page 48

Removing the Camera

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove:

a.battery

b.display assembly

c.display bezel

3.Perform the following steps as shown in the illustration:

a.Disconnect the camera cable.

b.Remove the screw that secures the camera module.

c.Lift the camera module from the computer.

Installing the Camera

1.Place the camera module in its slot in the computer.

2.Tighten the screw to secure the camera to the display assembly.

3.Connect the camera cable.

4.Install:

a.display bezel

b.display assembly

c.battery

5.Follow the procedures in After Working Inside Your Computer.

48

Image 48
Contents Regulatory Model P38G Regulatory Type P38G001 Dell Inc. All Rights Reserved Contents System Setup DiagnosticsTechnical Specifications Contacting Dell Page Working on Your Computer Before Working Inside Your ComputerTurning Off Your Computer Click Shut DownAfter Working Inside Your Computer Page Removing and Installing Components System OverviewInstalling the Secure Digital SD Card Removing the Secure Digital SD CardInstalling the ExpressCard Removing the BatteryInstalling the Battery Removing the ExpressCardInstalling the Base Cover Removing the Base CoverRemoving the Memory Installing the Memory Removing the Hard DriveInstalling the Hard Drive Removing the Optical DriveInstalling the Optical Drive Removing the Keyboard TrimInstalling the Keyboard Trim Removing the KeyboardPage Installing the Keyboard Removing the Wlan CardInstalling the Wlan Card Removing the Wwan CardInstalling the Wwan Card Installing the Base Corner CapsRemoving the Base Corner Caps Removing the Network Connector Installing the Network ConnectorRemoving the Coin-Cell Battery Installing the Coin-Cell BatteryRemoving the Heatsink Assembly Installing the Heatsink Assembly Installing the Processor Removing the Power ConnectorRemoving the Processor Page Installing the Power Connector Installing the Display-Hinge CoverRemoving the Display-Hinge Cover Removing the Palmrest Assembly Installing the Palmrest Assembly Removing the ExpressCard Cage Installing the ExpressCard Cage Removing the WiFi-Switch Board Installing the WiFi-Switch Board Removing the System BoardPage Installing the System Board Installing the Speakers Removing the SpeakersRemoving the I/O Board Installing the I/O Board Removing the Display Assembly Installing the Display Assembly Removing the Display Bezel Installing the Display Bezel Removing the Display Panel Flip the display panel over Installing the Display Panel Installing the Display Hinges Removing the Display HingesInstalling the Camera Removing the CameraBoot Sequence Navigation KeysKeys Navigation System Setup Options Advanced Boot Options Option DescriptionDate/Time Option Description Integrated NICEnable Smart Reporting USB ConfigurationUSB PowerShare Unobtrusive ModeSecurity features Drive does not have a password set by defaultEnter the old password Enter the new passwordPassword Configuration Password BypassPassword Change Allow Non-Admin Password Changes Default SettingDefault Setting Enable Intel SpeedStep Expert key ManagementOption Description Multi Core Support Intel SpeedStepWireless Radio Control Option Description AC BehaviorAuto On Time USB Wake SupportAdvanced Battery Charge ConfigurationPrimary Battery Charge Battery Slice ChargeOption Description Extend Bios Post Time Enable Intel Virtualization Technology Default SettingOption Description Wireless Switch Wireless Device EnableUpdating the Bios System and Setup PasswordClick Drivers & Downloads ComputerPress Y to save the changes. The computer reboots Enhanced Pre-Boot System Assessment ePSA Diagnostics Device Status LightsBattery Status Lights Storage LED Power LED Wireless LED Fault DescriptionAlternately Technical Specifications Feature SpecificationFeatures Specification UMAMemory card reader Support upto SD4.0 Battery Environmental Page Contacting Dell