1 
notch
2 
memory module 
3 
cutouts (2) 
4 
crossbar 
NOTICE: To avoid damage to the memory module, press the module straight down into the connector while you apply equal force to each end of the module.
5. Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
6.Replace the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
7.Connect your computer and devices to electrical outlets, and turn them on.
8.When a message appears stating that memory size has changed, press <F1> to continue.
9.Log on to your computer.
10.
11.Click the General tab.
12.To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
Cards
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.