Dell D17M manual Removing the Processor, Installing the Processor, Removing the Expansion Cards

Page 15

3.Connect the heatsink cable to the system board.

4.Install the cover.

5.Follow the procedures in After Working Inside Your Computer.

Removing the Processor

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the:

cover

heatsink

3.Push the processor release lever down and then press it outward to release it from the retention hook that secures it.

4.Raise the processor cover and lift the processor to remove it from the computer.

Installing the Processor

1.Install the processor into the socket.

2.Press down the processor cover to secure it inside the socket.

3.Push the release lever down and then press it inward to hold the retention hook that secures it.

4.Install the:

heatsink

cover

5.Follow the procedures in After Working Inside Your Computer.

Removing the Expansion Card(s)

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the cover.

15

Image 15
Contents Dell Vostro 3900/3902 Page Contents Troubleshooting Your Computer Before Working Inside Your Computer Working on Your ComputerTurning Off Your Computer After Working Inside Your Computer Removing and Installing Components Recommended ToolsSystem Overview Installing the Cover Removing the CoverRemoving the Bezel Removing the Hard Drive Installing the BezelInstalling the Hard Drive Removing the Optical Drive Installing the Optical DriveInstalling the Card Reader Removing the Card ReaderRemoving the Memory Installing the Memory Installing the HeatsinkRemoving the Heatsink Installing the Processor Removing the ProcessorRemoving the Expansion Cards Removing The Power Supply Unit PSU Installing the Expansion CardsInstalling the Power Supply Unit PSU Installing the Power Switch Removing the Power SwitchRemoving the Input/Output I/O Panel Installing the Input/Output I/O Panel Installing the System FanRemoving the System Fan Removing the System Board Installing the System BoardSystem Board Components Page Diagnostic Power LED Codes Troubleshooting Your ComputerDiagnostic Error Messages RUN System Setup Program HARD-DISK Drive Configuration ErrorInsert Bootable Media Invalid Configuration INFORMATION-PLEASENo Boot Sector on Hard Drive Licensed Content is not Accessible in MediadirectMemory Allocation Error No Boot Device AvailableNot Enough Memory or RESOURCES. Exit Seek ErrorTIME-OF-DAY Clock Lost Power \ is not ACCESSIBLE. the Device is not ReadySystem Error Messages System Setup Options System SetupSystem Setup Overview Enter System SetupSata AdvancedBoot Wlan PowerSpecifications PCI USBVAC-264 VAC Page Contacting Dell