Dell 960 manual Replacing the Battery

Page 2

Back to Contents Page

Battery

Dell™ Optiplex™ 960 Mini Tower/Desktop/Small Form Factor Service Manual

Replacing the Battery

Replacing the Battery

CAUTION: Before you begin any of the procedures in this section, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.

A coin-cell battery maintains computer configuration, date, and time information. The battery can last several years.

The battery may need replacing if an incorrect time or date is displayed during the boot routine along with a message such as:

Time-of-day not set - please run SETUP program

or

Invalid configuration information - please run SETUP program

or

Strike the F1 key to continue,

F2 to run the setup utility

To determine whether you need to replace the battery, reenter the time and date in system setup and exit the program to save the information. Turn off your

computer and disconnect it from the electrical outlet for a few hours; then reconnect the computer, turn it on, and enter system setup (see the DellTechnology Guide). If the date and time are not correct in system setup, replace the battery.

You can operate your computer without a battery; however, without a battery, the configuration information is erased if the computer is turned off or unplugged from the electrical outlet. In this case, you must enter system setup (see the DellTechnology Guide) and reset the configuration options.

CAUTION: A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions.

To remove the battery:

1.If you have not already done so, make a copy of your configuration information, found in system setup.

2.Perform the procedure Before Working on Your Computer.

3.Remove the computer cover.

4.Locate the battery socket.

NOTICE: If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with the object. Ensure that the object is inserted between the battery and the socket before you attempt to pry out the battery. Otherwise, you may damage the system board by prying off the socket or by breaking circuit traces on the system board.

NOTICE: To avoid damage to the battery connector, you must firmly support the connector while removing the battery.

5.Remove the system battery.

a.Support the battery connector by pressing down firmly on the positive side of the connector.

b.While supporting the battery connector, press the battery tab away from the positive side of the connector and pry the battery it up out of the securing tabs at the negative side of the connector.

Image 2
Contents Page Battery Replacing the BatteryPerform the procedure After Working on Your Computer Contacting Dell Desktop Computer Inside View of Your ComputerDesktop Computer PCI and PCIe Cards Installing a PCI CardCards Page Page Removing a PCI Card Installing a PCI Card in the Riser-Card Cage Page Perform the procedure in Before Working on Your Computer Removing a PCI Card From the Riser-Card CagePerform the procedure After Working on Your Computer Internal Wireless Card Installation Internal Wireless Card Removal Installing a Second External Serial PortReplacing the Chassis Intrusion Switch Chassis Intrusion SwitchRemoving the Chassis Intrusion Switch Resetting the Chassis Intrusion DetectorSave your Bios settings and exit system setup Replacing the Desktop Computer Cover Desktop Computer CoverRemoving the Desktop Computer Cover ALERT! Cover was previously removed Processor Removing the Heatsink AssemblyReplacing the Heatsink Assembly Installing the Processor Removing the ProcessorPerform the procedure After Working on Your Computer Remove and Replace the Fan and Shroud Assembly Data Interface Connectors General Installation Guidelines for Sata DevicesConnecting Drive Cables DrivesDrive Bay Inserts Power Cable ConnectorsConnecting and Disconnecting Drive Cables Removing Drive Bay InsertsRemoving an Optical Drive Optical DriveReplacing Drive Bay Inserts Installing an Optical Drive Removing a Floppy Drive Installing a Floppy DriveFloppy Drive Media Card Reader Installing a Media Card Reader Removing a Media Card ReaderHard Drive Removing the Primary Hard Drive Replacing the Primary Hard Drive Page Removing the Secondary Hard Drive Page Installing a Secondary Hard Drive Page Page Perform the procedure After Working on Your Computer Assembly Removing the I/O AssemblyReplacing the I/O Assembly Perform the procedure After Working on Your Computer Power Supply Replacing the Power SupplyDC Power Connectors DC Power Connector P1DC Power Connector P5 and P6 DC Power Connector P2DC Power Connector P4 Removing an Internal Speaker Installing an Internal SpeakerInternal Speaker Perform the procedure Before Working on Your Computer System Board Components DIMM4Addressing Memory Configurations DDR2 Memory OverviewInstalling Memory Removing Memory Mini Tower Computer Installing a PCI or PCIe Card Page FPerform the procedure After Working on Your Computer Removing a PCI or PCIe CardInternal Wireless Card Installation Internal Wireless Card Removal Chassis Intrusion Switch Save your Bios settings and exit system setup Replacing the Mini Tower Computer Cover Mini Tower Computer CoverRemoving the Mini Tower Computer Cover ALERT! Cover was previously removed Processor Removing the Processor Remove the Fan Assembly FPerform the procedure Before Working on Your ComputerReplacing the Fan Assembly Drives Removing a Hard Drive Perform the procedure Before Working on Your Computer Page Replacing a Hard Drive Page Perform the procedure After Working on Your Computer Remove the Drive Bezel Replace the Drive BezelReplacing or Installing the Floppy Drive Removing the Floppy DriveFPerform the procedure After Working on Your Computer Installing the Media Card Reader Removing the Media Card ReaderOptical Drive Replacing or Installing an Optical Drive FPerform the procedure After Working on Your Computer Assembly O assembly Securing screw O assembly cable connectors Remove the Bezel Replace the BezelPage Power Supply V12P0DIG White +3.3 VDC Orange +3.3VDC/SE 12 VDC Blue DC Power Connectors P3, P5, P8, and P9 DC Power Connector P7Internal Speaker Perform the procedure Before Working on Your Computer System Board Components Cards Perform the procedure After Working on Your Computer Removing a PCI Card Installing a PCIe x16 Card or DVI Card PCIe and DVI CardsRemoving a PCIe x16 Card or DVI Card Internal wireless card is an optional device Perform the procedure Before Working on Your Computer Internal Wireless Card Removal Chassis Intrusion Switch Back to Contents Replacing the Small Form Factor Computer Cover Small Form Factor Computer CoverRemoving the Small Form Factor Computer Cover ALERT! Cover was previously removed Processor Installing the Processor Page Remove and Replace the Fan and Shroud Assembly Page `Drives Data interface cable connector Sata interface connector Removing the Hard Drive and Shroud Assembly Removing the Hard Drive Replacing a Hard Drive Page Replacing the Hard Drive and Shroud Assembly Optical Drive Installing an Optical Drive Floppy Drive Installing a Floppy Drive Media Card Reader Replacing or Installing a Media Card Reader Perform the procedure After Working on Your Computer Remove the Bezel Replacing the BezelAssembly Perform the procedure After Working on Your Computer Power Supply VCC +5 Red DC Power Connector P3 Thermal Sensor P5 DC Power Connector P6+5VDC Internal Speaker Perform the procedure Before Working on Your Computer Fancpu Small Form Factor Computer Small Form Factor Computer Mini Tower System Board Screws Desktop System Board ScrewsSmall Form Factor System Board Screws Mini Tower Computer Back to Contents Tips Using the Hardware TroubleshooterPower Problems Steady Amber Steady Blue Computer does not start up Memory ProblemsLockups and Software Problems Program stops respondingStarting the Dell Diagnostics From Your Hard Drive Dell Technical Update Service Dell DiagnosticsOther software problems Program crashes repeatedlyInsert the Drivers and Utilities media Recommended Tools Before Working on Your ComputerAfter Working on Your Computer Turning Off Your Computer
Related manuals
Manual 76 pages 47.01 Kb Manual 70 pages 2.15 Kb

960 specifications

The Dell 960 is a powerful and efficient desktop computer designed for business environments and professional users seeking reliability and performance. This model is part of Dell's OptiPlex line, which is known for its focus on security, manageability, and sustainability.

One of the standout features of the Dell 960 is its compact design, which enables it to fit comfortably in various office environments without occupying much space. This small form factor is not only convenient for limited desk space but also enhances the aesthetic appeal of professional settings.

In terms of performance, the Dell 960 is equipped with Intel Core 2 Duo processors, offering dual-core processing capabilities that optimize multitasking and enhance overall system responsiveness. This makes it well-suited for running multiple applications simultaneously, an essential requirement in many business operations.

Memory options are customizable, allowing users to equip the Dell 960 with up to 8 GB of RAM. This flexibility ensures that the system can handle demanding applications and workloads with ease. Additionally, the desktop features various hard drive configurations, including both traditional hard disk drives (HDD) and solid-state drives (SSD), providing choices that balance performance and storage capacity.

The Dell 960 also prioritizes energy efficiency and eco-friendliness. It is Energy Star certified, meaning it meets stringent energy efficiency guidelines set by the U.S. Environmental Protection Agency. This certification helps organizations reduce their energy costs and carbon footprint, contributing to more sustainable operations.

For connectivity, the Dell 960 comes with a variety of ports, including USB 2.0 ports, audio jacks, and Ethernet ports, ensuring seamless communication with peripherals and networks. The inclusion of integrated graphics offers sufficient performance for standard business applications, while expansion slots allow for graphics upgrades when necessary.

Security features are robust in the Dell 960, with optional hardware-based security systems that safeguard sensitive data. With features like Trusted Platform Module (TPM) support and lockable chassis options, businesses can protect their valuable information from unauthorized access.

In summary, the Dell 960 blends performance, compactness, and energy efficiency, making it a suitable choice for offices and professional environments. Its customizable features ensure that users can tailor the desktop to meet their specific needs, while its emphasis on security and sustainability aligns well with modern corporate values.