After use, Inspection and repairs, Labels

(Original instructions)

ENGLISH

uThe hose has a double wall to reduce the surface tem- perature.

uYour unit is fitted with an overheat protection device (ther- mal cut-out) which will operate if the unit boils dry. Switch off, allow the unit to cool for 2 minutes and refill with water, preferably hot. The cut-out will automatically reset and steam will be produced within 5 to 10 minutes.

uYou should not allow the unit to be tilted as this may result in the overheat protection (thermal cut-out) operating lead- ing to excessive re-set times.

uIn the event of the steam pipe becoming blocked and excess pressure is evident, remove the plug from the electric supply. Do not try to open the filler cap until the unit has been allowed to cool for 2 minutes otherwise an interlock device will be activated inside the cap. The interlock device will reset itself once the unit has cooled thus allowing the cap to be removed.

After use

uSwitch off and remove the plug from the socket before leaving the appliance unattended and before changing, cleaning or inspecting any parts of the appliance.

uWhen not in use, the appliance should be stored in a dry place. Children should not have access to stored appli- ances.

Inspection and repairs

100OC

Never pull the unit by the hose.

Never use the steam plate directly above your head as hot water may drip.

Do not leave the unit unattended when switched on.

The steam plate becomes hot during use. Always hold the steam plate by the handle provided.

Danger of scalding, do not direct steam at persons, animals or anything which can be damaged.

Do not place the unit at an angle, do not use the unit on stairs.

The unit must be kept level at all times.

uBefore use, check the appliance for damaged or defective parts. Check for breakage of parts, damage to switches and any other conditions that may affect its operation.

uDo not use the appliance if any part is damaged or defec- tive.

uHave any damaged or defective parts repaired or replaced by an authorised repair agent.

uBefore use, check the power supply cord for signs of dam- age, ageing and wear.

uDo not use the appliance if the power supply cord or mains plug is damaged or defective.

uIf the power supply cord or mains plug is damaged or defective it must be repaired by an authorised repair agent in order to avoid a hazard. Do not cut the power supply cord and do not attempt to repair it yourself.

uNever attempt to remove or replace any parts other than those specified in this manual.

Labels

The following safety labels are found on your appliance.

Never pull the unit by the electric cable.

Warning symbols

The following symbols are used in this manual:

Read all of this manual carefully before using your appliance.

Always wear protective gloves.

Always wear eye protection.

Denotes risk of electric shock.

Surfaces may become hot during use and during the cool down period.