Bridged Connection for WAN
Home > WAN > Bridge Mode
For Bridged connections it will be necessary for most users to install additional software on any computer that will the Router for Internet access. The additional software is used for the purpose of identifying and verifying your account, and then granting Internet access to the computer requesting the connection. The connection software requires the user to enter the User Name and Password for the ISP account. This information is stored on the computer, not in the Router.
Follow the instructions
below to configure aWAN Settings Menu – Bridge Mode Bridged connection for
the WAN interface.
To configure a Dynamic IP Address connection, perform the steps listed below. Some of the settings do not need to be changed the first time the device is set up, but can be changed later if you choose. See the table below for a description of all the settings available in this menu.
1.Choose the Bridge Mode option from the WAN Settings
2.Under the ATM VC Settings at the top of the menu should not be changed unless you have been instructed to change them. However, if you are instructed to change the VPI or VCI values, type in the values assigned for your account. Leave the PVC and Virtual Circuit setting at the default (Pcv0 and Enabled) values for now. This can be used later if you are configuring multiple virtual circuits for your ADSL service. For more information on ATM VC Settings, see the table on page 31 below.
3.Under the Bridge Mode heading, choose the Connection Type from the
Page 24 of 94 | V1.00 AU |