| VoIP service provider did not give you a server port | |
| number for SIP. | |
Service Domain | Enter the SIP service domain name in this field. | |
|
| |
| Select | |
URL Scheme | domain name with the SIP number in the SIP | |
messages that it sends. Select | ||
| the router use the SIP number without a domain | |
| name in the SIP messages that it send. | |
| You can set this to phone or none. This | |
User Parameter | determines whether or not the phone number is | |
appended to the information forwarded to your SIP | ||
| server. Your VoIP service provider will instruct you | |
| which setting to use. | |
| You can set this to enabled or disabled. Some | |
| SIP servers can become unstable if you are | |
Initial Unregister | registered more than once (due to a power outage | |
and subsequent reboot of the router, for example). | ||
| This setting allows your router to “unregister” itself | |
| when it is rebooted, removing the previously sent | |
| registration information. | |
| Use this field to set how long the router will wait | |
Register Expires | before sending a repeat registration request if a | |
registration attempt fails or there is no response | ||
| ||
| from the registration server. | |
Session Expires | This field will set the longest time that the router | |
will allow a SIP session to remain idle (without | ||
| traffic) before dropping it. | |
| When two SIP devices negotiate a SIP session, they | |
| must negotiate a common expiration time for idle | |
| SIP sessions. This field sets the shortest expiration | |
| time that the router will accept. The router checks | |
| the session expiration values of incoming SIP | |
INVITE requests against the minimum session | ||
| expiration value that you enter here. If the session | |
| expiration of an incoming INVITE request is less | |
| than this value, the router negotiates with the other | |
| SIP device to increase the session expiration value | |
| to match the minimum session expiration value. | |
| This determines which side of an expired call | |
Session Expires Refresher | session will initiate the session refresh. uac – | |
specifies the Caller side will initiate the session | ||
| refresh. uas – specifies the Call receiver (the | |
| “Callee”) will initiate the session refresh. |
Page 41 of 94 | V1.00 AU |