NETGEAR WNDR3300f manual Configuring Your Wireless Network for Internet Access

Configuring Your Wireless Network for Internet Access

After installing your router, you must log into the router to complete your wireless setup. When you log in to the browser, you will be prompted to check for firmware updates from the NETGEAR update server.

Accessing Your Router After Installation and Checking for New Firmware

The Smart Wizard only appears when you first install the router or when the router is in its factory default state (for example, if you have reset the router to its factory default settings). If you want to change the settings after installing and configuring your router, you can click the desktop

shortcut—a preconfigured shortcut placed on your desktop by the Smart Wizard at installation—to open the router management interface.1 You can also change your settings, or configure your wireless and security settings, by opening a browser window and logging in to the router. You will also be prompted to check for new router firmware to the router. You will also be prompted to check for new router firmware.

To log in to the router after installation:

1.Open a browser window and type http://www.routerlogin.net in the address field of your

browser. Press Enter.

.

You can enter either of these addresses to connect to your wireless router:

http://www.routerlogin.net or http://www.routerlogin.com.

1. The shortcut icon is installed on your desktop only when using the Smart Wizard installation method.

Configuring Your Wireless Network for Internet Access 19