Configuring the PCs
Configuring Windows 95 or Windows 98 for IP Networking
All PCs must have an Ethernet adapter card installed and TCP/IP as their protocol. TCP/IP installation must be done manually.
To configure Windows 95 or Windows 98 for IP networking:
•Select the network properties from the Windows Control Panel.
Find your Ethernet adapter, TCP/IP protocol, and Client for Microsoft Networks. If these do not exist, you must add them.
To add an Ethernet adapter:
a.Click on Add.
b.Select Adapter.
c.Click on Add (again).
d.Select the manufacturer and model for the Ethernet adapter.
e.Click on OK.
To add TCP/IP:
a.Click on Add.
b.Click on Protocol.
c.Click on Add (again).
d.Select Microsoft.
e.Select TCP/IP.
f.Click on OK.
To add a Client for Microsoft Networks:
a.Click on Add.
b.Click on Client.
c.Click on Add (again).
d.Select Microsoft.
e.Select Client for Microsoft Networks.
f.Click on OK.
Restart your PC after making these changes.
Configuring TCP/IP Properties
NETGEAR recommends that you keep the default settings for the TCP/IP setup parameters, because your PC is configured to obtain its TCP/IP configuration information from a DHCP server on the LAN. The Model RT338 router is shipped preconfigured as a DHCP server and assigns the TCP/IP configuration.
To obtain the configuration information from the router:
1.Turn on power to the router.
Wait at least one minute before continuing to step 2.
2.Reboot each PC on your LAN.
Model RT338 ISDN Router Installation Guide