Apple MD031LL/A setup guide Regulatory Compliance Information

Page 38

Regulatory Compliance Information

FCC Declaration of Conformity

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. See instructions if interference to radio or television reception is suspected.

Radio and Television Interference

This computer equipment generates, uses, and can radiate radio- frequency energy. If it is not installed and used properly—that is, in strict accordance with Apple’s instructions—it may cause interference with radio and television reception.

This equipment has been tested and found to comply with the limits for a Class B digital device in accordance with the specifications in Part 15 of FCC rules. These specifications are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation.

You can determine whether your computer system is causing interference by turning it off. If the interference stops, it was probably caused by the computer or one of the peripheral devices.

If your computer system does cause interference to radio or television reception, try to correct the interference by using one or more of the following measures:

Turn the television or radio antenna until the interference stops.

Move the computer to one side or the other of the television or radio.

Move the computer farther away from the television or radio.

Plug the computer into an outlet that is on a different circuit from the television or radio. (That is, make certain the computer and the television or radio are on circuits controlled by different circuit breakers or fuses.)

If necessary, consult an Apple Authorized Service Provider or Apple. See the service and support information that came with your Apple product. Or, consult an experienced radio/television technician for additional suggestions.

Important:  Changes or modifications to this product not authorized by Apple Inc. could void the EMC compliance and negate your authority to operate the product.

This product was tested for FCC compliance under conditions that included the use of Apple peripheral devices and Apple shielded cables and connectors between system components. It is important that you use Apple peripheral devices and shielded cables and connectors between system components to reduce the possibility of causing interference to radios, television sets, and other electronic devices. You can obtain Apple peripheral devices and the proper shielded cables and connectors through an Apple- authorized dealer. For non-Apple peripheral devices, contact the manufacturer or dealer for assistance.

Responsible party (contact for FCC matters only) Apple Inc. Corporate Compliance

1 Infinite Loop M/S 26-A Cupertino, CA 95014

Wireless Radio Use

This device is restricted to indoor use when operating in the 5.15 to 5.25 GHz frequency band.

Cet appareil doit être utilisé à l’intérieur.

Exposure to Radio Frequency Energy

The radiated output power of the AirPort Card in this device is below the FCC and EU radio frequency exposure limits for uncontrolled equipment. This device should be operated with a minimum distance of at least 20 cm between the AirPort Card antennas and a person’s body and must not be co-located or operated with any other antenna or transmitter subject to the conditions of the FCC Grant.

38

Image 38
Contents Setup Guide Page Contents Regulatory Compliance Information Getting Started Getting Started About the AirPort Extreme AirPort Extreme has six ports, located on the backAbout the AirPort Software AirPort UtilityWhat You Need to Get Started Plugging In AirPort Extreme AirPort Extreme Status Light Light Status/descriptionWhat’s Next AirPort Extreme Networks Using the AirPort Extreme with a Broadband Internet Service To set it up Using the AirPort Extreme to Share a USB Printer To print from a computer using Windows To print from a computer using Mac OS X v10.5 or laterTo print from a computer using Mac OS X v10.2.7 or later Using the AirPort Extreme to Share USB Hard Disks To set it up Setting Up the Airport Extreme Using AirPort Utility On a Mac computer using Mac OS X v10.5.7 or laterCreating a New Wireless Network Configuring and Sharing Internet AccessSetting Up the Airport Extreme Setting Advanced Options To set advanced optionsAllowing Wireless Clients Access to Your Network To allow client access to your networkTo reset the base station password Tips and TroubleshootingIf You Forgot Your Network or Base Station Password If You Can’t Connect to the InternetTips and Troubleshooting To return your AirPort Extreme to the factory settings If Your AirPort Extreme Isn’t RespondingIf Your AirPort Extreme Status Light Flashes Amber On a computer using Windows On a Mac using Mac OS X v10.5 or laterOn a Mac using Mac OS X v10.2.7 or later If Your Printer Isn’t RespondingAirPort Extreme Placement Considerations Updating AirPort SoftwareItems That Can Cause Interference with AirPort Learning More, Service, and Support Online Resources Onscreen HelpObtaining Warranty Service AirPort Extreme Specifications and Safety Guidelines AppendixUsing your AirPort Extreme Safely About Operating and Storage Temperatures Regulatory Compliance Information Canadian Compliance Statement Singapore Wireless Certification Taiwan Class B Statement China Battery Statement Taiwan Battery Statement Page Printed