D-Link DIR-825 CE Mark Warning, FCC Statement, FCC Caution, FCC Radiation Exposure Statement

Page 106

Appendix E - Warranty

CE Mark Warning:

This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

FCC Statement:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC Caution:

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

IMPORTANT NOTICE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. To maintain compliance with FCC RF exposure compliance requirements, please avoid direct contact to the transmitting antenna during transmitting.

If this device is going to be operated in 5.15 ~ 5.25GHz frequency range, then it is restricted in indoor environment only. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

The availability of some specific channels and/or operational frequency bands are country dependent and are firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by the end user.

D-Link DIR-825 User Manual

102

Image 106
Contents Page Trademarks PrefaceManual Revisions Revision Date DescriptionTable of Contents Wireless Security RegistrationProductPackageOverviewContents Browser Requirements System RequirementsComputer with the following Utility RequirementsIntroduction Total PerformanceFeatures Hardware Overview ConnectionsInternet LED Power LEDLEDs Status LEDInstallation Before you BeginWireless Installation Considerations Connect to Cable/DSL/Satellite Modem Connect to Another Router Installation Click Install Router Getting StartedConfiguration Web-based Configuration UtilitySetup Wizard Click Launch Internet Connection Setup Wizard to beginConfiguration Configuration Configuration Manual Internet Connection Setup Click Manual Internet Connection Setup to beginPrimary Dynamic CableHost Name ServerPPPoE DSL Internet SetupConnection Pptp ManualPage Reconnect Mode Select either Always-on,On-Demand, or Manual L2TPPage Static assigned by ISP Wireless Settings Manual Wireless Settings 802.11n/g 2.4GHzPage 802.11n/a 5GHz Page Network Settings Router SettingsDhcp Server Settings Dhcp Reservation Virtual Server Configuration Port Forwarding Application Rules QoS Engine SpeedPage Network Filters Access Control Access Control WizardAccess Control Wizard Access Control Wizard Website Filters Add Website Select Allow or Deny Filtering RuleInbound Filters Enable SPI NAT Endpoint Filtering Firewall SettingsEnable DMZ Routing Advanced Wireless Settings Transmit Power Set the transmit power of the antennas802.11n/a 5GHz Wish Settings Page Wi-Fi Protected Setup WPS Reset PIN toStation Device WizardAdvanced Network Settings Enable UPnP WAN PingGuest Zone Security ModeSchedule Administrator Settings Time Settings SysLog SysLog Server SysLog ServerEmail Settings Authentication authenticationSystem Settings Update Firmware Check Email Notification of Newer FirmwareDdns System Check Schedules Device Information Log Statistics Internet Sessions Wireless WishSupport Wireless Security What is WPA?Wireless Security Setup Wizard Security Add Wireless Device with WPS Wizard Configure WPA-Personal PSK Next to Security Mode, select WPA-PersonalConfigure WPA-Enterprise Radius Next to Security Mode, select WPA-EnterpriseSecurity Connect to a Wireless Network Using Windows VistaConfigure Wireless Security Connecting to a Wireless Network Connect Using WCN 2.0 in Windows Vista Using Windows XP Configure WPA-PSK Connecting to a Wireless Network Troubleshooting Why can’t I access the web-based configuration utility?What can I do if I forgot my password? Troubleshooting Troubleshooting Wireless Basics What is Wireless? Wireless Local Area Network WlanHome Wireless Personal Area Network WpanSmall Office and Home Office Centralize your router or Access Point Eliminate InterferenceWireless Modes SecurityNetworking Basics Check your IP addressStatically Assign an IP address StepTechnical Specifications Contacting Technical Support For customers within the United StatesWarranty Limited Warranty Non-Applicability of Warranty Limited Software Warranty Submitting a Claim What Is Not Covered Disclaimer of Other WarrantiesTrademarks Limitation of LiabilityGoverning Law Copyright StatementFCC Caution CE Mark WarningFCC Statement FCC Radiation Exposure StatementIC Radiation Exposure Statement ICC NoticeRèglement d’Industry Canada Registration