D-Link DIR-825 manual Configuration

Page 20

Section 3 - Configuration

If you selected PPPoE, enter your PPPoE username and password. Click Next to continue.

Select Static if your ISP assigned you the IP address, subnet mask, gateway, and DNS server addresses.

Note: Make sure to remove your PPPoE software from your computer. The software is no longer needed and will not work through a router.

If you selected PPTP, enter your PPTP username and password. Click Next to continue.

If you selected L2TP, enter your L2TP username and password. Click Next to continue.

D-Link DIR-825 User Manual

16

Image 20

Contents Page Preface Manual RevisionsTrademarks Revision Date DescriptionTable of Contents Wireless Security RegistrationProductPackageOverviewContents System Requirements Computer with the followingBrowser Requirements Utility RequirementsIntroduction Total PerformanceFeatures Hardware Overview ConnectionsPower LED LEDsInternet LED Status LEDInstallation Before you BeginWireless Installation Considerations Connect to Cable/DSL/Satellite Modem Connect to Another Router Installation Click Install Router Getting StartedConfiguration Web-based Configuration UtilitySetup Wizard Click Launch Internet Connection Setup Wizard to beginConfiguration Configuration Configuration Manual Internet Connection Setup Click Manual Internet Connection Setup to beginDynamic Cable Host NamePrimary ServerConnection Internet SetupPPPoE DSL Pptp ManualPage Reconnect Mode Select either Always-on,On-Demand, or Manual L2TPPage Static assigned by ISP Wireless Settings Manual Wireless Settings 802.11n/g 2.4GHzPage 802.11n/a 5GHz Page Network Settings Router SettingsDhcp Server Settings Dhcp Reservation Virtual Server Configuration Port Forwarding Application Rules QoS Engine SpeedPage Network Filters Access Control Access Control WizardAccess Control Wizard Access Control Wizard Website Filters Add Website Select Allow or Deny Filtering RuleInbound Filters Enable DMZ Firewall SettingsEnable SPI NAT Endpoint Filtering Routing Advanced Wireless Settings Transmit Power Set the transmit power of the antennas802.11n/a 5GHz Wish Settings Page Wi-Fi Protected Setup WPS Reset PIN toStation Device WizardAdvanced Network Settings Enable UPnP WAN PingSchedule Security ModeGuest Zone Administrator Settings Time Settings SysLog SysLog Server SysLog ServerEmail Settings Authentication authenticationSystem Settings Update Firmware Check Email Notification of Newer FirmwareDdns System Check Schedules Device Information Log Statistics Internet Sessions Wireless WishSupport Wireless Security What is WPA?Wireless Security Setup Wizard Security Add Wireless Device with WPS Wizard Configure WPA-Personal PSK Next to Security Mode, select WPA-PersonalConfigure WPA-Enterprise Radius Next to Security Mode, select WPA-EnterpriseSecurity Connect to a Wireless Network Using Windows VistaConfigure Wireless Security Connecting to a Wireless Network Connect Using WCN 2.0 in Windows Vista Using Windows XP Configure WPA-PSK Connecting to a Wireless Network Troubleshooting Why can’t I access the web-based configuration utility?What can I do if I forgot my password? Troubleshooting Troubleshooting Wireless Basics What is Wireless? Wireless Local Area Network WlanSmall Office and Home Office Wireless Personal Area Network WpanHome Centralize your router or Access Point Eliminate InterferenceWireless Modes SecurityNetworking Basics Check your IP addressStatically Assign an IP address StepTechnical Specifications Contacting Technical Support For customers within the United StatesWarranty Limited WarrantySubmitting a Claim Limited Software WarrantyNon-Applicability of Warranty What Is Not Covered Disclaimer of Other WarrantiesLimitation of Liability Governing LawTrademarks Copyright StatementCE Mark Warning FCC StatementFCC Caution FCC Radiation Exposure StatementRèglement d’Industry Canada ICC NoticeIC Radiation Exposure Statement Registration