D-Link DFL-200 Set up built-in Dhcp server, Configure helper servers, Setup Wizard Complete

Page 8

Using The Setup Wizard (continued)

Step 4 - Set up built-in DHCP server

If you want to use the DFL-200’s built-in DHCP Server, choose Enable DHCP Server from this screen. You then need to specify a range of IP addresses to assign the DHCP clients. The range is entered in the format “Start IP – Stop IP” i.e. 192.168.0.100 – 192.168.0.200 or network/subnet mask address in bits, i.e. 192.168.0.0/24. If you don’t want to use the built-in DHCP Server or want to configure it later, choose Disable DHCP Server and click Next.

Click Next

Step 5 - Configure helper servers

NTP Servers - If enabled, specifies which NTP Servers should be used for time synchronization.

Syslog Servers – If enabled, specifies the server(s) where system log data is sent.

Click Next

Setup Wizard Complete

Click Restart to complete your configuration.

Click Restart

8

Image 8
Contents DFL-200 Power Receptor Page Using The Setup Wizard Welcome to the DFL-200 connection wizardSet timezone Set admin passwordConfigure WAN interface Static IP PPPoEBig Pond Setup Wizard Complete Set up built-in Dhcp serverConfigure helper servers Appendix IP Configuration Preferences. Click on Network Page Technical Support
Related manuals
Manual 14 pages 8.62 Kb Manual 133 pages 54.3 Kb