Linksys WET54G V3 manual Appendix H Regulatory Information, FCC Statement, Industry Canada Canada

Page 52

Wireless-G Ethernet Bridge

Appendix H: Regulatory Information

FCC STATEMENT

This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment or devices

Connect the equipment to an outlet other than the receiver's

Consult a dealer or an experienced radio/TV technician for assistance

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

INDUSTRY CANADA (CANADA)

This device complies with Canadian ICES-003 and RSS210 rules.

Cet appareil est conforme aux normes NMB-003 et RSS210 d'Industry Canada.

The use of this device in a system operating either partially or completely outdoors may require the user to obtain a license for the system according to the Canadian regulations.

EC DECLARATION OF CONFORMITY (EUROPE)

Linksys declares that this product conforms to the specifications listed below, following the provisions of the European R&TTE directive 1999/5/EC:

EN 301 489-1, 301 489-17 General EMC requirements for Radio equipment.

EN 609 50 Safety

Appendix H: Regulatory Information

46

Page 51 Page 53
Image 52
Page 51 Page 53
Contents Wireless- G How to Use this Guide Copyright and TrademarksTable of Contents Wireless-G Ethernet Bridge Infrastructure Network Ad-Hoc Network10 RADIUS-TTLS Introduction What’s in this Guide? Wireless-G Ethernet Bridge Ad-Hoc versus Infrastructure Mode Planning Your Wireless NetworkNetwork Topology Network Layout Ad-Hoc NetworkGettingtoKnowtheWireless-GEthernetBridge LANFront Panel Connecting the Wireless-G Ethernet Bridge for Setup Connect the PowerSetting Up the Wireless-G Ethernet Bridge WelcomeList of Bridges Wireless Settings Security Settings-WEP 10 Confirmation Connecting the Wireless-G Ethernet Bridge for Network Use Placement OptionsConnection to a Network Device Wall Mount OptionVertical Placement Stand OptionOverview Using the Wireless-G Ethernet Bridge Web-based UtilityStarting the Web-based Utility Setup WirelessSite Survey WEP WEPWPA Pre-Shared Key Radius MD5TLS RADIUS-TLSTtls 10 RADIUS-TTLSAdvanced Settings 11 Password TabMAC Address LAN Settings Wireless SettingsStatus LAN StatisticsHelp 14 Help TabAppendix a Troubleshooting Common Problems and SolutionsFrequently Asked Questions Web-based Utility won’t openWhat is ad-hoc mode? What is ISM band? Security Precautions Appendix B Wireless SecuritySecurity Threats Facing Wireless Networks Appendix B Wireless Security Wireless-G Ethernet Bridge Figure C-1 Firmware Upgrade Appendix C Upgrading FirmwareShared Resources Appendix D Windows HelpNetwork Neighborhood/My Network Places Appendix E Glossary Wireless-G Ethernet Bridge Wireless-G Ethernet Bridge Wireless-G Ethernet Bridge Wireless-G Ethernet Bridge Wireless-G Ethernet Bridge Appendix F Specifications Warranty Year Limited Storage TempOperating Humidity Storage HumidityAppendix G Warranty Information Limited WarrantyAppendix H Regulatory Information FCC StatementIndustry Canada Canada EC Declaration of Conformity EuropeSafety Notices FranceAppendix I Contact Information
Top Page Image Contents