Wireless-G Ethernet Bridge
Chapter3:GettingtoKnowtheWireless-GEthernetBridge
The Back Panel
All connections to the Bridge are made through the ports on its back panel, shown in Figure
Reset | When pressed, the Reset button resets the Bridge to its factory default settings. |
| Important: If you reset the |
| erase all of your settings (WEP encryption, wireless settings, |
| etc.) and replace them with the factory defaults. Do not reset the |
| |
LAN | The LAN port is where you will connect the Ethernet network cable. |
Power | The Power port is where you will connect the power adapter. |
| NOTE: If you use a Power over Ethernet (PoE) device to supply |
| data and power through the Ethernet network cable, then you |
| do not need to use the Power port. |
Figure 3-1: Back Panel
Chapter 3: Getting to Know the | 6 |
The Back Panel