INSTALLATION
LEG OPTION ON H2100
HEARTH HEATER
The addition of legs to the Hearth Heater does not alter its certification, it does not become a freestanding woodstove. The H2100 can only be installed as a Hearth Heater i.e. vented into a masonry or factory built fireplace.
The instructions below apply to the steel leg, painted cast leg and the gold plated cast leg. It will be easier to attach the legs to the stove if it is tipped on its back (preferably on a soft surface to prevent scratching).
1)Thread the bolt and washer through the leg, and then into the nutsert in the base of the stove and tighten.
2)Level the stove by adjusting the levelling bolts in the bottom of each leg.
NOTE: Adding the legs changes the height of the unit, make sure you have sufficient clear- ance (min. 28") for your flue connection. 
FLUE CONNECTOR
BRACKET
Package contains: 3 brackets and 6 screws.
INSTALLATION INTO A MASONRY FIREPLACE
The insert must be installed as per the require- ments of your local inspection authority. Three methods of flue connection are acceptable in most areas, these include:
1)Positive flue connection, where a large blocking plate and a short connector pipe is used.
2)Direct flue connection, where a smaller blocking plate and a connector pipe to the first flue liner tile is used.
3)Full flue liner, where a stainless steel rigid or flexible liner pipe is routed from the insert outlet collar to the top of the chimney.
Regency highly recommends the use of a full liner as the safest installation and provides the most optimum performance. Your retailer should be able to help you decide which system would be the best for your application.
1) Positive Flue | 2) Direct Flue | ||||||
Connection | Connection | ||||||
with Cleanout | with Cleanout | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The use of one of the connection methods listed on this page not only increases the safety of your insert by directing the hot gases up the flue, but will also help increase the unit's efficiency and decrease creosote deposits in the chimney.
When a connected flue or liner is in use, the insert is able to “breathe” better by allowing a greater draft to be created. The greater draft can decrease problems such as, difficult start- ups, smoking out the door, and dirty glass.
INSTALLATION INTO A
FACTORY BUILT
FIREPLACE
1)When installed in a factory built fireplace, a full stainless steel rigid or flexible flue liner is mandatory, for both safety and perform- ance purposes. When a flue or liner is in use, the insert is able to breathe better by allowing a greater draft to be created. The greater draft can decrease problems such as, difficult
2)In order to position the flue liner, the existing rain cap must be removed from your chim- ney system. In most cases the flue damper should also be removed to allow passage of the liner.
3)In most cases opening the existing spark screens fully should give enough room for the insert installation. If it does not, remove and store.
4)If the floor of your fireplace is below the level of the fireplace opening, adjust the insert's levelling bolts to accommodate the difference. When additional shimming is required, use
5)Measure approximately the alignment of the flue liner with the position of the smoke outlet hole on the insert to check for pos- sible offset. If an offset is required, use a
These brackets are to be used to hold the flue liner (not supplied) to the Insert and keep the connection. The brackets are screwed into the top of the Insert in the
3a) Full Flue Liner | 3b)Hearth Heater with |
(No Cleanout | Full Flue Liner |
Required) | (No Cleanout |
| Required) |
Note: A
Flush Inserts | Hearth Heater |
8 | Regency Insert & Hearth Heater |
