Regency I2100M installation manual Installation, Optional Flue Connector Kit

INSTALLATION

Position the grill on the inside bodyface side and fasten using the bolts, washers and nuts pro- vided (2 per side) as shown in the diagrams.

Note: The grill has a front and rear, the holes on the front side have rounded edges and the rear holes have flat edges.

View from Rear of Insert

OPTIONAL FLUE

CONNECTOR KIT

The optional Flue Connector Kit (Part # 846-527) and the Straight Flue Adaptor (Part #846-504) shown here, may be used to produce a secure connection between your flue connector and the insert collar. Detailed installation instructions are included with the kit.

MASONRY AND FACTORY BUILT FIREPLACE CLEARANCES

The minimum required clearances to combustible materials when installed into a masonry or factory built fireplace are listed below.

	Adjacent	Mantle**	Top	Side	Minimum	Minimum	Minimum
Unit	Side Wall	(to Top)	Facing	Facing	Hearth	Hearth	Hearth Side
	(to Side)		(to Top)	(to Side)	Extension*	Thickness*	Extension
	A	B	C	D	E	F	G
Small Flush
Insert (I1100S)	15"/380mm	20"/510mm	14"/355mm	7.375"/187mm	16"/406mm	1.5"/38mm	8"/205mm
Medium Flush
Insert (I2100M)	10"/255mm	17"/430mm	10.25"/260mm	8"/203mm	16"/406mm	1.5"/38mm	8"/205mm
Large Flush
Insert (I3100L)	13"/330mm	19"/480mm	18"/455mm	6.5"/165mm	16"/406mm	1.5"/38mm	8"/205mm
Hearth Heater
(H2100M)	10"/255mm	25"/635 mm	14"/355mm	8.5"/216mm	18"/455mm	1.5"/38mm	6"/152mm

Side and Top facing is a maximum of 1.5" thick. Floor protection must non-combustible, insula- tive material with an R value of 1.1 or greater.

*If the hearth extension is flush with the floor

(F)it must extend 19.5" in front of the body face (E).

Note: Hearth Extension Width (G) is measured from edge of fuel door to side of hearth.

**A non-combustible mantel may be installed at a lower height if the fram-

ing is made of metal studs covered with a non-combustible board.

Clearance diagram for installations

Regency Insert & Hearth Heater 7