INSTALLATION
proper stainless steel unit available with the chimney liner.
6)Once the above items have been checked, slide your insert into position after first positioning the flue liner and offset if re- quired.
FACEPLATE AND TRIM
Prior to sliding your insert into its final position and attaching the connector or liner pipe, the faceplate side panel plates must be installed as follows:
A) I1100S Small Insert
1)Fasten the faceplate mounting bracket to the side of the insert (one on each side) using the screws provided (2 screws per bracket). Diagram 1.
Diagram 1: I1100S
2)Assemble the faceplate sides and top with 4 screws. See Diagram 2.
Diagram 3: I1100S |
B) H2100M, I2100M and I3100L Inserts
1)Slide the spring nuts (supplied) over the slots in the insert’s side convection panels (the spring nuts may need to be squeezed with a pair of pliers first, to help them stay in position).
2)Screw the side faceplate panels, (item A in diagram 4) one to each side.
3)Using the top panel (item B in the diagram) as a gauge, check that the side panels are within approximately 1/4" of the overall width. If the difference is greater
than this, use the supplied washers to attain the re-
quired width.
C) All units
The unit may now be slid into final position and attached to the connection system.
Once connection is made, the insulation strips should be installed between the insert face- plates and the fireplace face. The faceplate top may now be installed (with insulation strip behind) by aligning its brackets with the top flange on the side shields and the angle iron bar on the insert top. The faceplate trim may be installed to the edge of the faceplate at this time.
I1100S: Drill two 5/32" diameter holes through the trim and side panels and screw the trim to the panels using the gold plated screws provid- ed.
Note: It may be easier to install the insu- lation, faceplate top and faceplate trim with the unit pulled slightly away from the fireplace face. If this is done, be very careful not to disturb the connector when shift- ing the unit to its final position.
Now that your insert is installed, check once more that all the clearances from the unit to any combustible materials are correct as listed earlier.
Diagram 2: I1100S
Rear View
3)Attach the assembled faceplate to the face-
plate mounting brackets. | Diagram 4: |
| |
| H2100M, I2100M |
| and I3100L |
| Faceplate |
| Assembly |
Regency Insert & Hearth Heater | 9 |
