INSTALLATION
FLOOR PROTECTION
Please check to ensure that your floor protec- tion and hearth will meet the standards for clearance to combustibles. Your hearth ex- tension must be made from a
FIREBRICK ASSEMBLY
Firebrick is included to extend the life of your insert and radiate heat more evenly. Check to see that all firebricks are in their correct positions and have not become misaligned during shipping.
BRICK FLUE BAFFLE & SECONDARY AIR TUBE INSTALLATION
The flue baffle system located in the upper area of the firebox is removable to make cleaning your chimney system easier. The brick baffles must be installed prior to your first fire. Smoke spillage and draft problems may occur if the baffles are improperly positioned. Check the position of the brick baffles on a regular basis as they can be dislodged if too much fuel is forced into the firebox.
The Large Insert I3100L is shipped with two of the secondary air tubes loose inside the fire- box. They need to be installed after the brick baffle are installed. Follow the directions be- low.
3)Important: push both baffle bricks so they are tight against the side walls.
Small Insert (I1100S)
Large Insert I3100L
The unit arrives with the first two air tubes (from the front) and the 2 baffle bricks on the floor of the firebox. The baffle bricks are positioned first and then the air tubes are installed.
NOTE: If the first 2 airtubes are already installed in the stove, they must be removed in order to install the Brick Baffles.
1)Slide the left baffle brick over the two rear air tubes and then push it all the way to the left side of the firebox.
Front View
4)Install the two front air tubes into the holes on the side channels. The notch goes on the right hand side with the air holes facing forward toward the door opening. If the tube will not slide in easily, simply use a pair of vise grips or pliers and tap it into place with a hammer. A tighter fit will ensure the tube will not move when the unit is burning.
Medium Insert (I2100M)
Large Insert (I3100L)
2) Tilt the first Baffle Brick down and then slide the 2nd Baffle Brick up and back. Reposi- tion both baffle bricks flat on the air tubes.
Hearth Heater (H2100M)
Note: When cleaning the chimney reverse the above procedures, removing the air tube and baffle bricks and then replace them when cleaning is completed.
Medium Insert I2100M
The unit arrives with the 2 baffle bricks on the floor of the firebox.
1)If all 3 air tubes are installed continue on to Step 2), if not, follow the instructions be- low. Install the air tube into the holes in the side channels. The notch goes on the right hand side with the air holes facing toward the door. Slide the tube into the left hand side, as far as possible and then bring it back into the hole on the right hand side until it locks into position. If the tube will not slide in easily, simply use a pair of vise grips or pliers and tap it into place with a hammer.
Regency Insert & Hearth Heater | 11 |