Linksys BEFSR41 v2 manual Buttons, Port Router’s Front Panel LEDs

Instant Broadband Series

Buttons

The Reset Button Details on the Reset button are found on page 7.

The 3-Port Router’s Front Panel LEDs

The LAN Indicators
Power	Green. The Power LED lights up green when the
	Router is powered on.
Link/Act	Green. The Link/Act LED serves two purposes. If
	the LED is continuously lit up, the Router is suc-
	cessfully connected to a device through the corre-
	sponding RJ-45 port (1, 2, or 3). If the LED flick-
	ers, then that port is sending or receiving data to
	and from the network.
Full/Col	Green. The Full/Col LED also serves two purpos-
	es. If this LED is continuously lit up, the connec-
	tion made through the corresponding port is suc-
	cessfully running in Full Duplex mode. If the
	LED is flickering, the connection is experiencing
	collisions. Infrequent collisions are normal.
	If this LED flickers too often, there may be a
	problem with your connection. See the
	Troubleshooting section if you have problems.

EtherFast Cable/DSL Routers

100	Orange. The 100 LED lights up when a
	successful 100Mbps connection is made
	through the corresponding port. If this
	LED does not light up, then your connec-
	tion speed is 10 Mbps.
USB	The USB LED lights up when the USB
	port is successfully connected to a PC,
	USB hub, or other USB device.
The WAN Indicators
Link	Green. The Link LED lights up when a successful connec-
	tion is made between the Router and your broadband device
	or network.
Act	Green. The Act LED flickers when the Router is sending or
	receiving data over the broadband WAN port.
Diag	Orange. The Diag LED lights up when the Router goes
	through its self-diagnostic test during boot-up. It will turn
	off upon successful completion of the diagnosis. This LED
	will also light up when you make changes in the Utility and
	click Apply to save them.

If this LED stays on for an abnormally long period of time, see the Troubleshooting section.

13 14