ADC 75 Ohm Interconnect manual 0 6 1 0 3 9 7 8 a E Digital Monitor Module System

1 2 / 0 6 • 1 0 3 9 7 8 A E Digital Monitor Module System

Digital Monitor Module System

75 Ohm Interconnect

Application

The DMM system is used primarily in co-location environments, DDF locations, and customer premises as a connection point between NEs. Each NE is semipermanently cabled to IN/OUT connectors in either the front or rear of each module. The digital signal is accessed through the two MON OUT connectors on the front of each module for testing and monitoring. These dual monitor ports allow access to both directions of the circuit from a single location. This saves valuable technician time when the other side of the termination is located far away, in another room, or is inaccessible.

	Network￿				Network￿
Element A		DMM		Element Z
		MON	OUT		Tx OUT
			IN
		Z-OUT			Rx IN
	Tx OUT				￿
			OUT
	Rx IN		IN
		MON
		A-OUT

Test

Unit

w w w . a d c . c o m • + 1 - 9 5 2 - 9 3 8 - 8 0 8 0 • 1 - 8 0 0 - 3 6 6 - 3 8 9 1 2