Actiontec electronic Wireless-Ready user manual Regulatory Compliance Notices, Modifications

Page 64

Notices

Regulatory Compliance Notices

Class B Equipment

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that inter- ference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by implementing one or more of the following measures:

Reorient or relocate the receiving antenna;

Increase the separation between the equipment and receiver;

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected;

Consult the dealer or an experienced radio or television technician for help.

Modifications

The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Actiontec Electronics, Inc., may void the user’s authority to operate the equipment.

Declaration of conformity for products marked with the FCC logo – United States only.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference;

61

Image 64
Contents Wireless-Ready DSL Gateway Table of Contents Computer Security Introduction1 Package ContentsMinimum System Requirements Technical Support Actiontec Electronics, IncConnecting Gateway Connecting the Power and DSL CableActiontec Wireless-Ready DSL Gateway Connecting to a Computer EthernetUSB Connecting the Phone Filters Connecting Network Computers Wireless Actiontec Wireless-Ready DSL Gateway Configuring Gateway Actiontec Wireless-Ready DSL Gateway Configuring the Gateway Actiontec Wireless-Ready DSL Gateway Connecting to the Internet Using Qwest DSLDisconnecting from the Internet Actiontec Wireless-Ready DSL Gateway Basic Setup Actiontec Wireless-Ready DSL Gateway Gateway Features Actiontec Wireless-Ready DSL Gateway Basic Setup Actiontec Wireless-Ready DSL Gateway Advanced Setup Accessing Advanced SetupWAN IP Address Obtain an IP Address through PPPoE or PPPoA Obtain an IP Through Dhcp Specify a Static IP AddressWireless Equivalent Privacy Wireless SettingsChannel Off LAN IP Address Dhcp Server Configuration Dhcp ServerServices Blocking Website Blocking VPN Pass ThroughRemote Management Port Forwarding DMZ HostingMAC Address Cloning StatusActiontec Wireless-Ready DSL Gateway Utilities7 Web Activity LogRestore Default Settings DSL SettingsUpgrade Firmware Utilities Actiontec Wireless-Ready DSL Gateway Troubleshooting LAN Connection FailureTime out error occurs when entering a URL or IP Address Reference Locating Computer InformationWindows 98, 98 SE Locating Windows Operating System FilesWindows Me Windows NT Wiring Information Two-Line PhoneSecurity Alarm System Automatic Water Meter PBX or Key SystemComputer Security Anti-Virus Programs Internet Browsers Actiontec Wireless-Ready DSL Gateway Specifications C GeneralWireless Operating Range LED IndicatorsEnvironmental Actiontec Wireless-Ready DSL Gateway Glossary ISP Internet Service Provider MAC Media Access Control AddressFirewall GatewayWeca Wireless Ethernet Compatibility Alliance Wlan Wireless Local Area NetworkSubnet Mask TCP/IP Transmission Control Protocol/Internet ProtocolActiontec Wireless-Ready DSL Gateway Modifications Regulatory Compliance NoticesClass B Equipment Actiontec Wireless-Ready DSL Gateway Limited Warranty Actiontec Electronics, Inc North Mary Avenue Sunnyvale, CA Limited Warranty