Advantek Networks Wireless LAN 802.11g/b, 54Mbps/2.4GHz Broadband Router with Firewall Support

Most Linux installations use fixed IP address, if you wish to use a fixed IP address, make sure make the following changes.

a)Set “Default Gateway” with the IP address of the wireless router.

b)Make sure DNS settings are correct.

To act as a DHCP Client (recommended)

The procedures below may vary depending on version of Linux and X-windows shell.

a)Start X-Windows.

b)Select Control Panel Æ Network.

c)Select the “Interface” entry for your Network card. Normally, this is called “eth0”.

d)Click “Edit” button, set the “protocol” to “DHCP” and save.

e)To apply all changes, use Deactivate and Activate buttons, if it is possible, restart your system.

2.3Configure Wireless Station

This section describes how to configure all the wireless stations use Wireless Router as an Access Point. Each wireless station must have compatible settings as below.

Mode	All wireless stations must be set to “Infrastructure” mode.
SSID	This code must match the value uses for the Wireless Router. (Note: SSID
(ESSID)	code is case sensitive.)
WEP	By default, WEP encryption is set to 64-bits 10 hex digit.
WPA	By default, WPA-PSK Pass Phrase is set at PassPhrase, WPA G-Rekey
	Interval is set at 0 and WPA Data Encryption is at TKIP.

20