Allied Telesis 86241-02 manual PCR 02346 Module BGP, IPGNetwork affecting No

Page 6

6Patch Release Note

PCR: 02346 Module: BGP, IPGNetwork affecting: No

It is now possible to set a preference value for dynamically learned routes based on their protocol using the command:

SET IP ROUTE PREFERENCE={DEFAULT1..65535}

PROTOCOL={BGP-EXTBGP-INTOSPF-EXT1OSPF-EXT2OSPF-INTER

OSPF-INTRAOSPF-OTHERRIP}

PCR: 02347

Module: SWI

Network affecting: No

The CREATE CONFIGURATION command was not correctly generating the DISABLE SWITCH HWFILTER and DISABLE SWITCH L3FILTER commands. This issue has been resolved.

PCR: 02348 Module: ENCO

Network affecting: No

When the PAC card was under severe load, the related driver occasionally did not fully transfer all result data from the chip. This caused an actCmdFail error. This issue has been resolved.

PCR: 02354

Module: SCC, SYN, PPP

Network affecting: No

In a previous patch, a fatal error occurred after a RESTART ROUTER command was executed when using PPP over SYN. Also, on AR745 models, PPP was using an 8 MB boundary instead of a 16 MB boundary. These issues have been resolved.

PCR: 02357

Module: FR

Network affecting: No

The following issues have been resolved:

•PIM was not sending Hello messages over a Frame Relay (FR) interface.

•A fatal error occurred if 64 was entered as the interface value in the DESTROY FRAMERELAY command. The command now only accepts 0-63 for this parameter.

•The ADD FRAMERELAY DLC command incorrectly accepted a TYPE parameter. Also, this command was not accepting the ENCAPSULATION parameter.

•The CREATE CONFIGURATION command incorrectly generated the CIR and CIRLIMITED parameters for the ADD FRAMERELAY DLC command.

•FR interfaces with static DLCs were always shown as DOWN. The status of the interface was not being updated when a circuit was added to the interface.

PCR: 02359

Module: IPG

Network affecting: No

When an IP Multihomed interface was used as an OSPF interface, neighbour relationships were only established if the IP interface for OSPF was added first in the configuration. Now, OSPF establishes neighbour relationships regardless of the IP Multihomed interface configuration order.

PCR: 02363

Module: FFS, FILE, TTY

Network affecting: No

The FLASH compaction process is now transparent to the file edition process. The FLASH system is now more stable.

Patch 86241-02 for Software Release 2.4.1 C613-10340-00 REV B

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Introduction Features PCR 02277 Module Dvmrp Network affecting No PCR Module IPG, PIM, SWI Network affecting NoPCR Module Tpad Network affecting No PCR Module TELNET, TTY Network affecting NoPCR Module Install Network affecting No PCR Module IPv6 Network affecting NoPCR Module STP Network affecting No PCR Module IPG, ETH Network affecting No PCR Module FR Network affecting NoPCR Module IPG/FIREWALL Network affecting No PCR Module Classifier Network affecting NoPCR Module SCC, SYN, PPP Network affecting No PCR 02346 Module BGP, IPGNetwork affecting NoPCR 02348 Module Enco Network affecting No PCR Module FFS, FILE, TTY Network affecting NoPCR 02376 Module PPPNetwork affecting No PCR 02369 Module IPGNetwork affecting NoPCR 02371 Module FIREWALLNetwork affecting No PCR 02378 Module SWINetwork affecting NoPCR Module Trace Network affecting No PCR Module SNMP, CORE, SHOW, Network affecting NoPCR Module IPG Network affecting No Module Vrrp PCR 02457 Module IPV6Network affecting No PCR 02450 Module IPV6Network affecting NoPCR 02452 Module IPv6Network affecting No PCR 02463 Module DVMRP, IPG Network affecting NoPCR Module Switch Network affecting No Availability PCR Module DHCP, IPG Network affecting NoPatch Release Note
Top Page Image Contents